From: Basharath Hussain Khaja <basharath@couthit.com>
To: danishanwar@ti.com, rogerq@kernel.org, andrew+netdev@lunn.ch,
davem@davemloft.net, edumazet@google.com, kuba@kernel.org,
pabeni@redhat.com, robh@kernel.org, krzk+dt@kernel.org,
conor+dt@kernel.org, nm@ti.com, ssantosh@kernel.org,
tony@atomide.com, richardcochran@gmail.com, parvathi@couthit.com,
basharath@couthit.com, schnelle@linux.ibm.com,
rdunlap@infradead.org, diogo.ivo@siemens.com,
m-karicheri2@ti.com, horms@kernel.org, jacob.e.keller@intel.com,
m-malladi@ti.com, javier.carrasco.cruz@gmail.com, afd@ti.com,
s-anna@ti.com
Cc: linux-arm-kernel@lists.infradead.org, netdev@vger.kernel.org,
devicetree@vger.kernel.org, linux-kernel@vger.kernel.org,
linux-omap@vger.kernel.org, pratheesh@ti.com, prajith@ti.com,
vigneshr@ti.com, praneeth@ti.com, srk@ti.com, rogerq@ti.com,
krishna@couthit.com, pmohan@couthit.com, mohan@couthit.com
Subject: [RFC v2 PATCH 09/10] net: ti: prueth: Adds power management support for PRU-ICSS
Date: Fri, 24 Jan 2025 20:15:54 +0530 [thread overview]
Message-ID: <20250124144555.1462044-10-basharath@couthit.com> (raw)
In-Reply-To: <20250124122353.1457174-1-basharath@couthit.com>
From: Roger Quadros <rogerq@ti.com>
Changes for supporting the sleep/resume feature for PRU-ICSS.
PRU-ICSS will be kept in IDLE mode for optimal power consumption by Linux
power management subsystem and will be resumed when it is required.
Signed-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Andrew F. Davis <afd@ti.com>
Signed-off-by: Parvathi Pudi <parvathi@couthit.com>
Signed-off-by: Basharath Hussain Khaja <basharath@couthit.com>
---
drivers/net/ethernet/ti/icssm/icssm_prueth.c | 62 ++++++++++++++++++++
1 file changed, 62 insertions(+)
diff --git a/drivers/net/ethernet/ti/icssm/icssm_prueth.c b/drivers/net/ethernet/ti/icssm/icssm_prueth.c
index fdc97ed9c1fb..a3c8c746ebf8 100644
--- a/drivers/net/ethernet/ti/icssm/icssm_prueth.c
+++ b/drivers/net/ethernet/ti/icssm/icssm_prueth.c
@@ -2300,6 +2300,67 @@ static void icssm_prueth_remove(struct platform_device *pdev)
pru_rproc_put(prueth->pru0);
}
+#ifdef CONFIG_PM_SLEEP
+static int icssm_prueth_suspend(struct device *dev)
+{
+ struct prueth *prueth = dev_get_drvdata(dev);
+ struct net_device *ndev;
+ int i, ret;
+
+ for (i = 0; i < PRUETH_NUM_MACS; i++) {
+ ndev = prueth->registered_netdevs[i];
+
+ if (!ndev)
+ continue;
+
+ if (netif_running(ndev)) {
+ netif_device_detach(ndev);
+ ret = icssm_emac_ndo_stop(ndev);
+ if (ret < 0) {
+ netdev_err(ndev, "failed to stop: %d", ret);
+ return ret;
+ }
+ }
+ }
+
+ pruss_cfg_ocp_master_ports(prueth->pruss, 0);
+
+ return 0;
+}
+
+static int icssm_prueth_resume(struct device *dev)
+{
+ struct prueth *prueth = dev_get_drvdata(dev);
+ struct net_device *ndev;
+ int i, ret;
+
+ pruss_cfg_ocp_master_ports(prueth->pruss, 1);
+
+ for (i = 0; i < PRUETH_NUM_MACS; i++) {
+ ndev = prueth->registered_netdevs[i];
+
+ if (!ndev)
+ continue;
+
+ if (netif_running(ndev)) {
+ ret = icssm_emac_ndo_open(ndev);
+ if (ret < 0) {
+ netdev_err(ndev, "failed to start: %d", ret);
+ return ret;
+ }
+ netif_device_attach(ndev);
+ }
+ }
+
+ return 0;
+}
+
+#endif /* CONFIG_PM_SLEEP */
+
+static const struct dev_pm_ops prueth_dev_pm_ops = {
+ SET_SYSTEM_SLEEP_PM_OPS(icssm_prueth_suspend, icssm_prueth_resume)
+};
+
/* AM57xx SoC-specific firmware data */
static struct prueth_private_data am57xx_prueth_pdata = {
.fw_pru[PRUSS_PRU0] = {
@@ -2324,6 +2385,7 @@ static struct platform_driver prueth_driver = {
.driver = {
.name = "prueth",
.of_match_table = prueth_dt_match,
+ .pm = &prueth_dev_pm_ops,
},
};
module_platform_driver(prueth_driver);
--
2.34.1
next prev parent reply other threads:[~2025-01-24 14:47 UTC|newest]
Thread overview: 31+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-01-24 12:23 [RFC v2 PATCH 00/10] PRU-ICSSM Ethernet Driver Basharath Hussain Khaja
2025-01-24 12:23 ` [RFC v2 PATCH 01/10] dt-bindings: net: ti: Adds DUAL-EMAC mode support on PRU-ICSS2 for AM57xx SOCs Basharath Hussain Khaja
2025-01-24 16:39 ` Conor Dooley
2025-01-29 5:16 ` Basharath Hussain Khaja
2025-01-29 17:48 ` Conor Dooley
2025-02-03 12:29 ` Basharath Hussain Khaja
2025-02-04 18:16 ` Conor Dooley
2025-01-24 12:23 ` [RFC v2 PATCH 02/10] net: ti: prueth: Adds ICSSM Ethernet driver Basharath Hussain Khaja
2025-01-30 11:41 ` Simon Horman
2025-02-01 13:25 ` Basharath Hussain Khaja
2025-01-24 12:23 ` [RFC v2 PATCH 03/10] net: ti: prueth: Adds PRUETH HW and SW configuration Basharath Hussain Khaja
2025-01-30 15:47 ` Simon Horman
2025-02-01 13:34 ` Basharath Hussain Khaja
2025-01-24 12:37 ` [RFC v2 PATCH 04/10] net: ti: prueth: Adds link detection, RX and TX support Basharath Hussain Khaja
2025-01-24 23:13 ` Joe Damato
2025-01-29 5:41 ` Basharath Hussain Khaja
2025-01-30 16:45 ` Simon Horman
2025-02-01 13:37 ` Basharath Hussain Khaja
2025-01-24 13:40 ` Basharath Hussain Khaja
2025-01-24 23:20 ` Joe Damato
2025-01-29 5:43 ` Basharath Hussain Khaja
2025-01-24 13:40 ` [RFC v2 PATCH 05/10] net: ti: prueth: Adds ethtool support for ICSSM PRUETH Driver Basharath Hussain Khaja
2025-01-30 17:23 ` Simon Horman
2025-02-01 13:48 ` Basharath Hussain Khaja
2025-01-24 13:40 ` [RFC v2 PATCH 06/10] net: ti: prueth: Adds HW timestamping support for PTP using PRU-ICSS IEP module Basharath Hussain Khaja
2025-01-31 10:33 ` Simon Horman
2025-02-05 12:24 ` Basharath Hussain Khaja
2025-01-24 13:40 ` [RFC v2 PATCH 07/10] net: ti: prueth: Adds support for network filters for traffic control supported by PRU-ICSS Basharath Hussain Khaja
2025-01-24 14:45 ` [RFC v2 PATCH 08/10] net: ti: prueth: Adds support for RX interrupt coalescing/pacing Basharath Hussain Khaja
2025-01-24 14:45 ` Basharath Hussain Khaja [this message]
2025-01-24 14:45 ` [RFC v2 PATCH 10/10] arm: dts: ti: Adds device tree nodes for PRU Cores, IEP and eCAP modules of PRU-ICSS2 Instance Basharath Hussain Khaja
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20250124144555.1462044-10-basharath@couthit.com \
--to=basharath@couthit.com \
--cc=afd@ti.com \
--cc=andrew+netdev@lunn.ch \
--cc=conor+dt@kernel.org \
--cc=danishanwar@ti.com \
--cc=davem@davemloft.net \
--cc=devicetree@vger.kernel.org \
--cc=diogo.ivo@siemens.com \
--cc=edumazet@google.com \
--cc=horms@kernel.org \
--cc=jacob.e.keller@intel.com \
--cc=javier.carrasco.cruz@gmail.com \
--cc=krishna@couthit.com \
--cc=krzk+dt@kernel.org \
--cc=kuba@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=m-karicheri2@ti.com \
--cc=m-malladi@ti.com \
--cc=mohan@couthit.com \
--cc=netdev@vger.kernel.org \
--cc=nm@ti.com \
--cc=pabeni@redhat.com \
--cc=parvathi@couthit.com \
--cc=pmohan@couthit.com \
--cc=prajith@ti.com \
--cc=praneeth@ti.com \
--cc=pratheesh@ti.com \
--cc=rdunlap@infradead.org \
--cc=richardcochran@gmail.com \
--cc=robh@kernel.org \
--cc=rogerq@kernel.org \
--cc=rogerq@ti.com \
--cc=s-anna@ti.com \
--cc=schnelle@linux.ibm.com \
--cc=srk@ti.com \
--cc=ssantosh@kernel.org \
--cc=tony@atomide.com \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox