[PATCH 6.1 10/22] counter: stm32-lptimer-cnt: fix error handling when enabling

[Greg Kroah-Hartman <gregkh@linuxfoundation.org>]

6.1-stable review patch.  If anyone has any objections, please let me know.

------------------

From: Fabrice Gasnier <fabrice.gasnier@foss.st.com>

commit 8744dcd4fc7800de2eb9369410470bb2930d4c14 upstream.

In case the stm32_lptim_set_enable_state() fails to update CMP and ARR,
a timeout error is raised, by regmap_read_poll_timeout. It may happen,
when the lptimer runs on a slow clock, and the clock is gated only
few times during the polling.

Badly, when this happen, STM32_LPTIM_ENABLE in CR register has been set.
So the 'enable' state in sysfs wrongly lies on the counter being
correctly enabled, due to CR is read as one in stm32_lptim_is_enabled().

To fix both issues:
- enable the clock before writing CMP, ARR and polling ISR bits. It will
avoid the possible timeout error.
- clear the ENABLE bit in CR and disable the clock in the error path.

Fixes: d8958824cf07 ("iio: counter: Add support for STM32 LPTimer")
Signed-off-by: Fabrice Gasnier <fabrice.gasnier@foss.st.com>
Link: https://lore.kernel.org/r/20250224170657.3368236-1-fabrice.gasnier@foss.st.com
Signed-off-by: William Breathitt Gray <wbg@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
 drivers/counter/stm32-lptimer-cnt.c |   24 +++++++++++++++---------
 1 file changed, 15 insertions(+), 9 deletions(-)

--- a/drivers/counter/stm32-lptimer-cnt.c
+++ b/drivers/counter/stm32-lptimer-cnt.c
@@ -58,37 +58,43 @@ static int stm32_lptim_set_enable_state(
 		return 0;
 	}
 
+	ret = clk_enable(priv->clk);
+	if (ret)
+		goto disable_cnt;
+
 	/* LP timer must be enabled before writing CMP & ARR */
 	ret = regmap_write(priv->regmap, STM32_LPTIM_ARR, priv->ceiling);
 	if (ret)
-		return ret;
+		goto disable_clk;
 
 	ret = regmap_write(priv->regmap, STM32_LPTIM_CMP, 0);
 	if (ret)
-		return ret;
+		goto disable_clk;
 
 	/* ensure CMP & ARR registers are properly written */
 	ret = regmap_read_poll_timeout(priv->regmap, STM32_LPTIM_ISR, val,
 				       (val & STM32_LPTIM_CMPOK_ARROK) == STM32_LPTIM_CMPOK_ARROK,
 				       100, 1000);
 	if (ret)
-		return ret;
+		goto disable_clk;
 
 	ret = regmap_write(priv->regmap, STM32_LPTIM_ICR,
 			   STM32_LPTIM_CMPOKCF_ARROKCF);
 	if (ret)
-		return ret;
+		goto disable_clk;
 
-	ret = clk_enable(priv->clk);
-	if (ret) {
-		regmap_write(priv->regmap, STM32_LPTIM_CR, 0);
-		return ret;
-	}
 	priv->enabled = true;
 
 	/* Start LP timer in continuous mode */
 	return regmap_update_bits(priv->regmap, STM32_LPTIM_CR,
 				  STM32_LPTIM_CNTSTRT, STM32_LPTIM_CNTSTRT);
+
+disable_clk:
+	clk_disable(priv->clk);
+disable_cnt:
+	regmap_write(priv->regmap, STM32_LPTIM_CR, 0);
+
+	return ret;
 }
 
 static int stm32_lptim_setup(struct stm32_lptim_cnt *priv, int enable)