[PATCH 6.1 22/22] ARM: dts: imx6qdl-apalis: Fix poweroff on Apalis iMX6

[Greg Kroah-Hartman <gregkh@linuxfoundation.org>]

6.1-stable review patch.  If anyone has any objections, please let me know.

------------------

From: Stefan Eichenberger <stefan.eichenberger@toradex.com>

commit 83964a29379cb08929a39172780a4c2992bc7c93 upstream.

The current solution for powering off the Apalis iMX6 is not functioning
as intended. To resolve this, it is necessary to power off the
vgen2_reg, which will also set the POWER_ENABLE_MOCI signal to a low
state. This ensures the carrier board is properly informed to initiate
its power-off sequence.

The new solution uses the regulator-poweroff driver, which will power
off the regulator during a system shutdown.

Cc: <stable@vger.kernel.org>
Fixes: 4eb56e26f92e ("ARM: dts: imx6q-apalis: Command pmic to standby for poweroff")
Signed-off-by: Stefan Eichenberger <stefan.eichenberger@toradex.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
Signed-off-by: Stefan Eichenberger <stefan.eichenberger@toradex.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
 arch/arm/boot/dts/imx6qdl-apalis.dtsi |   10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

--- a/arch/arm/boot/dts/imx6qdl-apalis.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-apalis.dtsi
@@ -101,6 +101,11 @@
 		};
 	};
 
+	poweroff {
+		compatible = "regulator-poweroff";
+		cpu-supply = <&vgen2_reg>;
+	};
+
 	reg_module_3v3: regulator-module-3v3 {
 		compatible = "regulator-fixed";
 		regulator-always-on;
@@ -220,10 +225,6 @@
 	status = "disabled";
 };
 
-&clks {
-	fsl,pmic-stby-poweroff;
-};
-
 /* Apalis SPI1 */
 &ecspi1 {
 	cs-gpios = <&gpio5 25 GPIO_ACTIVE_LOW>;
@@ -511,7 +512,6 @@
 
 	pmic: pmic@8 {
 		compatible = "fsl,pfuze100";
-		fsl,pmic-stby-poweroff;
 		reg = <0x08>;
 
 		regulators {