Re: [PATCH v2 0/6] BQ24190 charger fixes

[Mark Greer <mgreer@animalcreek.com>]

On Mon, Jan 16, 2017 at 11:42:06AM -0800, Liam Breck wrote:
> On Mon, Jan 16, 2017 at 9:30 AM, Mark Greer <mgreer@animalcreek.com> wrote:
> > On Sun, Jan 15, 2017 at 10:05:26PM -0800, Liam Breck wrote:
> >> Changes in v2:
> >>
> >> #1 reorders:            Fix irq triggering to IRQF_TRIGGER_FALLING
> >> #2 factors out part of: Call power_supply_changed() only for relevant component
> >> #3 replaces:            Call enable_irq() only at the end of probe()
> >> #4 reorders:            Call power_supply_changed() only for relevant component
> >> #5 unscrambles:         Don't read fault register outside irq_handle_thread()
> >> #6 factors out part of: Don't read fault register outside irq_handle_thread()
> >>
> >> These are dropped; Tony will resubmit them in new patchset:
> >>   Check the interrupt status on resume
> >>   Use PM runtime autosuspend
> >
> > Hi Liam - a couple notes:
> > - please include the full original text from v1 with the text above
> >   added to it;
> > - please thread the emails like you did with v1
> 
> Hi Mark. There was no v1 0/n preamble. It would have read:
> 
> "v1: Misc fixes, tested on a custom OMAP3 board."

Okay, I assumed it was v2 following up on Tony's patch series which did
have a 0/6.  For some reason, I don't have your v1 series in my inbox -
sometimes I'm too quick with the delete button so I may have deleted it
accidentally.

Mark
--