Re: convert raid10 to raid0

["Tóth Csaba" <csaba.toth@i3rendszerhaz.hu>]

2010.07.08. 0:50 keltezéssel, Neil Brown írta:
> Then after you create the raid0, use the same command
>    mdadm -E /dev/sdc6
> to check the Data Offset again and make sure it is the same.
> I suspect it will be, so everything will be fine.
> However if it isn't don't try to access the array.   Post the details and I'll
> figure out what to do next.
> 

It doesn't work, and the data offsets are different (in the mean time i
figured out that i made a mistake, and not sdc6 but sdb6 is the other
correct device):

Old:
sdb6: 592 sectors
sdd6: 264 sectors

New:
sdb6: 2048 sectors
sdd6: 2048 sectors

if i modify the source code of the mdadm, but don't know how to make it
to set differently based on the partition..

thanks in advance!
Csaba
--
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html