[PATCH v2 4/6] s390/vfio_ap: verify ZAPQ completion after return of response code zero

[Tony Krowiak <akrowiak@linux.ibm.com>]

Verification that the asynchronous ZAPQ function has completed only needs
to be done when the response code indicates the function was successfully
initiated; so, let's call the apq_reset_check function immediately after
the response code zero is returned from the ZAPQ.

Signed-off-by: Tony Krowiak <akrowiak@linux.ibm.com>
Reviewed-by: Jason J. Herne <jjherne@linux.ibm.com>
Reviewed-by: Harald Freudenberger <freude@linux.ibm.com>
---
 drivers/s390/crypto/vfio_ap_ops.c | 7 +++----
 1 file changed, 3 insertions(+), 4 deletions(-)

diff --git a/drivers/s390/crypto/vfio_ap_ops.c b/drivers/s390/crypto/vfio_ap_ops.c
index a443ee5f7789..e1b05e749570 100644
--- a/drivers/s390/crypto/vfio_ap_ops.c
+++ b/drivers/s390/crypto/vfio_ap_ops.c
@@ -1656,6 +1656,9 @@ static int vfio_ap_mdev_reset_queue(struct vfio_ap_queue *q)
 	switch (status.response_code) {
 	case AP_RESPONSE_NORMAL:
 		ret = 0;
+		/* if the reset has not completed, wait for it to take effect */
+		if (!status.queue_empty || status.irq_enabled)
+			ret = apq_reset_check(q);
 		break;
 	case AP_RESPONSE_RESET_IN_PROGRESS:
 		/*
@@ -1685,10 +1688,6 @@ static int vfio_ap_mdev_reset_queue(struct vfio_ap_queue *q)
 		return -EIO;
 	}
 
-	/* wait for the reset to take effect */
-	if (!(status.queue_empty && !status.irq_enabled))
-		ret = apq_reset_check(q);
-
 free_resources:
 	vfio_ap_free_aqic_resources(q);
 
-- 
2.31.1