Re: [PATCH v15 1/6] KVM: s390: pv: asynchronous destroy for reboot

[Steffen Eiden <seiden@linux.ibm.com>]

On 10/10/22 16:54, Claudio Imbrenda wrote:
> Until now, destroying a protected guest was an entirely synchronous
> operation that could potentially take a very long time, depending on
> the size of the guest, due to the time needed to clean up the address
> space from protected pages.
> 
> This patch implements an asynchronous destroy mechanism, that allows a
> protected guest to reboot significantly faster than previously.
> 
> This is achieved by clearing the pages of the old guest in background.
> In case of reboot, the new guest will be able to run in the same
> address space almost immediately.
> 
> The old protected guest is then only destroyed when all of its memory
> has been destroyed or otherwise made non protected.
> 
> Two new PV commands are added for the KVM_S390_PV_COMMAND ioctl:
> 
> KVM_PV_ASYNC_CLEANUP_PREPARE: set aside the current protected VM for
> later asynchronous teardown. The current KVM VM will then continue
> immediately as non-protected. If a protected VM had already been
> set aside for asynchronous teardown, but without starting the teardown
> process, this call will fail. There can be at most one VM set aside at
> any time. Once it is set aside, the protected VM only exists in the
> context of the Ultravisor, it is not associated with the KVM VM
> anymore. Its protected CPUs have already been destroyed, but not its
> memory. This command can be issued again immediately after starting
> KVM_PV_ASYNC_CLEANUP_PERFORM, without having to wait for completion.
> 
> KVM_PV_ASYNC_CLEANUP_PERFORM: tears down the protected VM previously
> set aside using KVM_PV_ASYNC_CLEANUP_PREPARE. Ideally the
> KVM_PV_ASYNC_CLEANUP_PERFORM PV command should be issued by userspace
> from a separate thread. If a fatal signal is received (or if the
> process terminates naturally), the command will terminate immediately
> without completing. All protected VMs whose teardown was interrupted
> will be put in the need_cleanup list. The rest of the normal KVM
> teardown process will take care of properly cleaning up all remaining
> protected VMs, including the ones on the need_cleanup list.
> 
> Signed-off-by: Claudio Imbrenda <imbrenda@linux.ibm.com>
> Reviewed-by: Nico Boehr <nrb@linux.ibm.com>
> Reviewed-by: Janosch Frank <frankja@linux.ibm.com>
Reviewed-by: Steffen Eiden <seiden@linux.ibm.com>

[snip]