messages from 2015-07-29 08:09:01 to 2015-08-10 04:04:05 UTC [more...]
[PATCH 1/8] serial: imx: remove unbalanced clk_prepare
2015-08-10 4:04 UTC (10+ messages)
` [PATCH 2/8] serial: imx: introduce serial_imx_enable_wakeup()
` [PATCH 3/8] serial: imx: allow waking up on RTSD
` [PATCH 4/8] serial: imx: use dev_pm_ops
` [PATCH 5/8] serial: imx: save and restore context in the suspend path
` [PATCH 6/8] serial: imx: add a flag to indicate we are "
` [PATCH 7/8] serial: imx: add runtime pm support
` [PATCH 8/8] serial: imx: add pm_qos request
[PATCH v3] serial: 8250: Fix autoconfig_irq() to avoid race conditions
2015-08-10 0:15 UTC
[PATCH v5 00/11] drivers: PL011: add ARM SBSA Generic UART support
2015-08-09 0:59 UTC (3+ messages)
` [PATCH v5 05/11] drivers: PL011: refactor pl011_probe()
[PATCH 0/5] drivers/tty: make more bool drivers explicitly non-modular
2015-08-09 0:51 UTC (3+ messages)
` [PATCH 4/5] drivers/tty: make serial/mpsc.c driver "
` [PATCH 5/5] drivers/tty: make serial 8250_lpc18xx.c "
omap-dma + 8250_omap: fix the dmaengine_pause()
2015-08-08 15:40 UTC (10+ messages)
` [PATCH 1/3] tty: serial: 8250_omap: do not use RX DMA if pause is not supported
` [PATCH 2/3] dma: add __must_check annotation for dmaengine_pause()
` [PATCH v3 3/3] dma: omap-dma: add support for pause of non-cyclic transfers
[PATCH] dma: omap-dma: add support for pause of non-cyclic transfers
2015-08-08 9:07 UTC (29+ messages)
[PATCH v2] dma: omap-dma: add support for pause of non-cyclic transfers
2015-08-07 18:47 UTC (4+ messages)
[PATCH v4 1/2] serial: mxs-auart: use a function name to reflect what it really does
2015-08-07 15:30 UTC (3+ messages)
` [PATCH v4 2/2] serial: mxs-auart: keep the AUART unit in reset state when not in use
[PATCH 3/3] serial: 8250: omap: restore registers on shutdown
2015-08-07 0:41 UTC (12+ messages)
g_serial hangs on write when the cable is disconnected
2015-08-06 16:16 UTC (15+ messages)
[RFC PATCH v2 0/3] genirq, serial: 8250: Workaround to avoid irq=0 for console
2015-08-06 12:53 UTC (17+ messages)
` [RFC PATCH v2 1/3] serial: 8250: Fix autoconfig_irq() to avoid race conditions
` [RFC PATCH v2 2/3] genirq: Add a function to set irq affinity of candidate IRQs
` [RFC PATCH v2 3/3] serial: 8250: Fix autoconfig_irq() to reduce the risk of failure
[PATCHv2 0/2] tty: serial: men_z135_uart.c: Updates for men_z135_uart
2015-08-06 11:29 UTC (4+ messages)
` [PATCH 2/2] tty: serial: men_z135_uart.c: Don't initialize port->lock
` [PATCHv2 1/2] tty: serial: men_z135_uart.c: Fix race between IRQ and set_termios()
[PATCH v2 0/9] [New BSP] Add initial support for Freescale Kinetis TWR-K70F120M development kit
2015-08-05 19:27 UTC (14+ messages)
` [PATCH v2 3/9] arm: twr-k70f120m: clock driver for Kinetis SoC
[PATCH 0/7] tty core debug patches
2015-08-05 19:22 UTC (5+ messages)
` [PATCH 2/7] tty: core: Add tty_debug() for printk(KERN_DEBUG) messages
[PATCH] tty: serial: men_z135_uart.c: Fix race between IRQ and set_termios()
2015-08-05 19:17 UTC (6+ messages)
[PATCHv2] serial: don't register CIR serial ports
2015-08-05 19:02 UTC (2+ messages)
[PATCH] Fix data loss in cdc-acm
2015-08-05 17:36 UTC (15+ messages)
[PATCH] serial: don't register CIR serial ports
2015-08-05 15:25 UTC (4+ messages)
[PATCH] serial: don't announce CIR serial ports
2015-08-05 12:35 UTC (7+ messages)
[PATCH 1/1] serial: 8250_pci: fix mode after S3/S4 resume for F81504/508/512
2015-08-05 6:44 UTC
[PATCH 0/4] *** 8250_dw ***
2015-08-03 23:44 UTC (4+ messages)
` [v2 2/3] serial: 8250_dw: dw8250_setup_port() use endianness aware read
` [v2 3/3] serial: 8250_dw: Add UPF_SKIP_TEST to flags depend on device tree
` [v2 1/3] serial: 8250_dw: Add support for big-endian MMIO accesses
[PATCH 1/1] tty/serial: jsm: Added spaces in if sentences and around binary operators
2015-08-03 23:33 UTC (2+ messages)
[PATCH 1/2] pci_ids: Add Pericom vendor and device ids
2015-08-03 5:14 UTC (5+ messages)
` [PATCH 2/2] serial: 8250_pci: Add support for Pericom PI7C9X795[1248]
[PATCH v2 0/2] serial: samsung: fix DMA for small FIFO sizes
2015-08-03 0:37 UTC (4+ messages)
` [PATCH v2 1/2] serial: samsung: fix DMA mode enter condition "
` [PATCH v2 2/2] serial: samsung: fix DMA for FIFO smaller than cache line size
[PATCH] serial: 8250: bind to ALi Fast Infrared Controller (ALI5123)
2015-08-02 21:15 UTC
[PATCH] serial: 8250: don't bind to SMSC IrCC IR port
2015-08-02 21:11 UTC
[PATCH v2 08/11] serial: Allow compile test of GPIO consumers if !GPIOLIB
2015-08-02 9:09 UTC
[PATCH] serial: etraxfs-uart: remove empty functions
2015-08-01 15:00 UTC (2+ messages)
[PATCH] serial: etraxfs-uart: use mctrl_gpio helpers for handling modem signals
2015-08-01 15:00 UTC (2+ messages)
[PATCH V3] tty: serial: imx.c: Reset UART before activating interrupts
2015-07-31 12:04 UTC (2+ messages)
[PATCH 0/2] serial: samsung: fix DMA for small FIFO sizes
2015-07-31 8:17 UTC (5+ messages)
` [PATCH 1/2] serial: samsung: calculate min_dma_size
` [PATCH 2/2] serial: samsung: fix DMA for FIFO smaller than cache line size
[PATCH linux-next 1/1] tty/serial: at91: fix I/O accesses on RHR and THR for AVR32
2015-07-31 7:03 UTC (5+ messages)
[PATCH 1/3] serial: 8250: unlock port for uart_write_wakeup()
2015-07-30 23:53 UTC (3+ messages)
[PATCH 2/3] serial: 8250: move rx_running out of the bitfield
2015-07-30 23:24 UTC (2+ messages)
[PATCH 0/3] serial: 8250: fix locking/race/cleanup issues
2015-07-30 22:54 UTC
[PATCH v5 1/1] Serial: imx: add dev_pm_ops to support suspend to ram/disk
2015-07-30 15:32 UTC
[PATCH v4 1/1] Serial: imx: add dev_pm_ops to support suspend to ram/disk
2015-07-30 15:19 UTC (3+ messages)
[PATCH v1 1/2] dt: atmel-usart: document new I/O data register width property
2015-07-30 13:54 UTC (4+ messages)
` [PATCH v1 2/2] atmel_serial: set 32-bit access by default
[PATCH v3 1/1] Serial: imx: add dev_pm_ops to support suspend to ram/disk
2015-07-30 9:34 UTC (8+ messages)
[PATCH 1/1] Changed some lines according to coding style in drivers/tty/serial/jsm
2015-07-30 6:51 UTC (3+ messages)
[PATCH v4 0/5] tty/serial: at91: add support to FIFOs
2015-07-29 15:34 UTC (6+ messages)
` [PATCH v4 4/5] "
[PATCH V2 1/1] serial: 8250_pci: add RS485 for F81504/508/512
2015-07-29 12:01 UTC (2+ messages)
[PATCH 0/2] serial: 8250: Workaround to avoid irq=0 for console
2015-07-29 8:13 UTC (18+ messages)
` [PATCH 1/2] serial: 8250: Fix autoconfig_irq() to avoid race conditions
` [PATCH 2/2] serial: 8250: Allow to skip autoconfig_irq() for a console
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).