Re: [PATCH 00/13 v2] sh-pfc: Initial r8a73a4 PFC support

[Simon Horman <horms@verge.net.au>]

On Tue, Mar 26, 2013 at 10:49:39PM +0900, Magnus Damm wrote:
> sh-pfc: Initial r8a73a4 PFC support (V2)
> 
> [PATCH 01/13] sh-pfc: Add r8a73a4 pinmux support
> [PATCH 02/13] sh-pfc: r8a73a4: Support sparse GPIO numbers
> [PATCH 03/13 v2] sh-pfc: r8a73a4: GPIO IRQ support
> [PATCH 04/13] sh-pfc: r8a73a4: Add bias (pull-up/down) pinconf support
> [PATCH 05/13] sh-pfc: r8a73a4: Add SCIF pin groups and functions
> [PATCH 06/13] sh-pfc: r8a73a4: Add IRQC pin groups and functions
> [PATCH 07/13] sh-pfc: r8a73a4: Remove SCIF function GPIOS
> [PATCH 08/13] sh-pfc: r8a73a4: Remove IRQC function GPIOS
> [PATCH 09/13] ARM: shmobile: r8a73a4: Remove SCIF function GPIOs
> [PATCH 10/13] ARM: shmobile: r8a73a4: Remove IRQC function GPIOs
> [PATCH 11/13] sh-pfc: r8a73a4: Remove function GPIOs
> [PATCH 12/13] ARM: shmobile: r8a73a4: Remove all GPIO enums
> [PATCH 13/13] sh-pfc: r8a73a4: Remove unused GPIO bias data
> 
> This series is V2 of initial PFC support for the r8a73a4 SoC.
> The patches add a regular old-style GPIO function controller
> and makes it partially converted over to PINCTRL for SCIF
> and IRQC that are tied up on the APE6EVM board. The final
> patches remove the GPIO function support, so when new drivers
> for r8a73a4 are added then PINCTRL support has to be included.

Hi Magnus,

I apologise if the information is obvious or available elsewhere,
but could you let me know a bit about the dependencies for this series.

I am assuming it depends on:

[PATCH 00/03 v3] ARM: shmobile: r8a73a4 APE6EVM board support
[PATCH/RFC 00/12] Split PFC and GPIO for R8A7779

Laurent, if/when this series is ready do you want to take it
or should I add it to my tree directly?