[PATCH v2 0/2] Add Ether DT support for R8A7790/Lager reference board

[PATCH v2 0/2] Add Ether DT support for R8A7790/Lager reference board

[Sergei Shtylyov]

Hello.

   Here's the set of 2 patches against Simon Horman's 'renesas.git' repo,
'renesas-devel-v3.14-rc3-20140218' tag. Here we add the Ether device tree
support on the R8A7790/Lager reference board. The patchset requires the
'sh_eth' driver device tree support just merged to the 'net-next.git' repo in
order to work.

[1/2] ARM: shmobile: r8a7790: add Ether DT support
[2/2] ARM: shmobile: lager: add Ether DT support

WBR, Sergei

[PATCH v2 1/2] ARM: shmobile: r8a7790: add Ether DT support

[Sergei Shtylyov]

Define the generic R8A7790 part of the Ether device node. 

Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>

---
Changes in version 2:
- removed now redundant "interrupt-parent" property;
- refreshed the patch.

 arch/arm/boot/dts/r8a7790.dtsi |   14 +++++++++++++-
 1 file changed, 13 insertions(+), 1 deletion(-)

Index: renesas/arch/arm/boot/dts/r8a7790.dtsi
=================================--- renesas.orig/arch/arm/boot/dts/r8a7790.dtsi
+++ renesas/arch/arm/boot/dts/r8a7790.dtsi
@@ -1,7 +1,8 @@
 /*
  * Device Tree Source for the r8a7790 SoC
  *
- * Copyright (C) 2013 Renesas Solutions Corp.
+ * Copyright (C) 2013-2014 Renesas Solutions Corp.
+ * Copyright (C) 2014 Cogent Embedded Inc.
  *
  * This file is licensed under the terms of the GNU General Public License
  * version 2.  This program is licensed "as is" without any warranty of any
@@ -379,6 +380,17 @@
 		status = "disabled";
 	};
 
+	ether: ethernet@ee700000 {
+		compatible = "renesas,ether-r8a7790";
+		reg = <0 0xee700000 0 0x400>;
+		interrupts = <0 162 IRQ_TYPE_LEVEL_HIGH>;
+		clocks = <&mstp8_clks R8A7790_CLK_ETHER>;
+		phy-mode = "rmii";
+		#address-cells = <1>;
+		#size-cells = <0>;
+		status = "disabled";
+	};
+
 	sata0: sata@ee300000 {
 		compatible = "renesas,sata-r8a7790";
 		reg = <0 0xee300000 0 0x2000>;

[PATCH v2 2/2] ARM: shmobile: lager: add Ether DT support

[Sergei Shtylyov]

Define the Lager board dependent part of the Ether device node. 

Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>

---
Changes in version 2:
- moved PHY pin node phandle from PHY device node to the Ether device node, thus
  removing all pin control properties from the PHY node;
- resolved reject.

 arch/arm/boot/dts/r8a7790-lager.dts |   28 +++++++++++++++++++++++++++-
 1 file changed, 27 insertions(+), 1 deletion(-)

Index: renesas/arch/arm/boot/dts/r8a7790-lager.dts
=================================--- renesas.orig/arch/arm/boot/dts/r8a7790-lager.dts
+++ renesas/arch/arm/boot/dts/r8a7790-lager.dts
@@ -1,7 +1,8 @@
 /*
  * Device Tree Source for the Lager board
  *
- * Copyright (C) 2013 Renesas Solutions Corp.
+ * Copyright (C) 2013-2014 Renesas Solutions Corp.
+ * Copyright (C) 2014 Cogent Embedded, Inc.
  *
  * This file is licensed under the terms of the GNU General Public License
  * version 2.  This program is licensed "as is" without any warranty of any
@@ -124,6 +125,16 @@
 		renesas,function = "scif0";
 	};
 
+	ether_pins: ether {
+		renesas,groups = "eth_link", "eth_mdio", "eth_rmii";
+		renesas,function = "eth";
+	};
+
+	phy1_pins: phy1 {
+		renesas,groups = "intc_irq0";
+		renesas,function = "intc";
+	};
+
 	scif1_pins: serial1 {
 		renesas,groups = "scif1_data";
 		renesas,function = "scif1";
@@ -150,6 +161,21 @@
 	};
 };
 
+&ether {
+	pinctrl-0 = <&ether_pins &phy1_pins>;
+	pinctrl-names = "default";
+
+	phy-handle = <&phy1>;
+	renesas,ether-link-active-low;
+	status = "ok";
+
+	phy1: ethernet-phy@1 {
+		reg = <1>;
+		interrupt-parent = <&irqc0>;
+		interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
+	};
+};
+
 &mmcif1 {
 	pinctrl-0 = <&mmc1_pins>;
 	pinctrl-names = "default";

[PATCH v2 0/2] Add Ether DT support for R8A7791/Koelsch reference board

[Sergei Shtylyov]

Hello.

   Here's the set of 2 patches against Simon Horman's 'renesas.git' repo,
'renesas-devel-v3.14-rc3-20140218' tag. Here we add the Ether device tree
support on the R8A7791/Koelsch reference board. The patchset requires
the 'sh_eth' driver device tree support just merged to the 'net-next.git' repo
in order to work.

[1/2] ARM: shmobile: r8a7791: add Ether DT support
[2/2] ARM: shmobile: koelsch: add Ether DT support

WBR, Sergei

[PATCH v2 1/2] ARM: shmobile: r8a7791: add Ether DT support

[Sergei Shtylyov]

Define the generic R8A7791 part of the Ether device node. 

Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>

---
Changes in version 2:
- removed now redundant "interrupt-parent" property;
- refreshed the patch.

 arch/arm/boot/dts/r8a7791.dtsi |   14 +++++++++++++-
 1 file changed, 13 insertions(+), 1 deletion(-)

Index: renesas/arch/arm/boot/dts/r8a7791.dtsi
=================================--- renesas.orig/arch/arm/boot/dts/r8a7791.dtsi
+++ renesas/arch/arm/boot/dts/r8a7791.dtsi
@@ -2,7 +2,8 @@
  * Device Tree Source for the r8a7791 SoC
  *
  * Copyright (C) 2013 Renesas Electronics Corporation
- * Copyright (C) 2013 Renesas Solutions Corp.
+ * Copyright (C) 2013-2014 Renesas Solutions Corp.
+ * Copyright (C) 2014 Cogent Embedded Inc.
  *
  * This file is licensed under the terms of the GNU General Public License
  * version 2.  This program is licensed "as is" without any warranty of any
@@ -407,6 +408,17 @@
 		status = "disabled";
 	};
 
+	ether: ethernet@ee700000 {
+		compatible = "renesas,ether-r8a7791";
+		reg = <0 0xee700000 0 0x400>;
+		interrupts = <0 162 IRQ_TYPE_LEVEL_HIGH>;
+		clocks = <&mstp8_clks R8A7791_CLK_ETHER>;
+		phy-mode = "rmii";
+		#address-cells = <1>;
+		#size-cells = <0>;
+		status = "disabled";
+	};
+
 	sata0: sata@ee300000 {
 		compatible = "renesas,sata-r8a7791";
 		reg = <0 0xee300000 0 0x2000>;

[PATCH v2 2/2] ARM: shmobile: koelsch: add Ether DT support

[Sergei Shtylyov]

Define the Koelsch board dependent part of the Ether device node. 

Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>

---
Changes in version 2:
- moved PHY pin node phandle from PHY device node to the Ether device node, thus
  removing all pin control properties from the PHY node;
- refreshed the patch.

 arch/arm/boot/dts/r8a7791-koelsch.dts |   28 +++++++++++++++++++++++++++-
 1 file changed, 27 insertions(+), 1 deletion(-)

Index: renesas/arch/arm/boot/dts/r8a7791-koelsch.dts
=================================--- renesas.orig/arch/arm/boot/dts/r8a7791-koelsch.dts
+++ renesas/arch/arm/boot/dts/r8a7791-koelsch.dts
@@ -2,7 +2,8 @@
  * Device Tree Source for the Koelsch board
  *
  * Copyright (C) 2013 Renesas Electronics Corporation
- * Copyright (C) 2013 Renesas Solutions Corp.
+ * Copyright (C) 2013-2014 Renesas Solutions Corp.
+ * Copyright (C) 2014 Cogent Embedded, Inc.
  *
  * This file is licensed under the terms of the GNU General Public License
  * version 2.  This program is licensed "as is" without any warranty of any
@@ -146,12 +147,37 @@
 		renesas,function = "scif1";
 	};
 
+	ether_pins: ether {
+		renesas,groups = "eth_link", "eth_mdio", "eth_rmii";
+		renesas,function = "eth";
+	};
+
+	phy1_pins: phy1 {
+		renesas,groups = "intc_irq0";
+		renesas,function = "intc";
+	};
+
 	qspi_pins: spi {
 		renesas,groups = "qspi_ctrl", "qspi_data4";
 		renesas,function = "qspi";
 	};
 };
 
+&ether {
+	pinctrl-0 = <&ether_pins &phy1_pins>;
+	pinctrl-names = "default";
+
+	phy-handle = <&phy1>;
+	renesas,ether-link-active-low;
+	status = "ok";
+
+	phy1: ethernet-phy@1 {
+		reg = <1>;
+		interrupt-parent = <&irqc0>;
+		interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
+	};
+};
+
 &sata0 {
 	status = "okay";
 };

Re: [PATCH v2 0/2] Add Ether DT support for R8A7791/Koelsch reference board

[Simon Horman]

On Thu, Feb 20, 2014 at 02:24:59AM +0300, Sergei Shtylyov wrote:
> Hello.
> 
>    Here's the set of 2 patches against Simon Horman's 'renesas.git' repo,
> 'renesas-devel-v3.14-rc3-20140218' tag. Here we add the Ether device tree
> support on the R8A7791/Koelsch reference board. The patchset requires
> the 'sh_eth' driver device tree support just merged to the 'net-next.git' repo
> in order to work.
> 
> [1/2] ARM: shmobile: r8a7791: add Ether DT support
> [2/2] ARM: shmobile: koelsch: add Ether DT support

Thanks, I have queued these up.

Re: [PATCH v2 0/2] Add Ether DT support for R8A7790/Lager reference board

[Simon Horman]

On Thu, Feb 20, 2014 at 02:18:22AM +0300, Sergei Shtylyov wrote:
> Hello.
> 
>    Here's the set of 2 patches against Simon Horman's 'renesas.git' repo,
> 'renesas-devel-v3.14-rc3-20140218' tag. Here we add the Ether device tree
> support on the R8A7790/Lager reference board. The patchset requires the
> 'sh_eth' driver device tree support just merged to the 'net-next.git' repo in
> order to work.
> 
> [1/2] ARM: shmobile: r8a7790: add Ether DT support
> [2/2] ARM: shmobile: lager: add Ether DT support

Thanks, I have queued these up.