* AZT1008 on HP Vectra VL6
@ 2002-11-25 18:37 Ofer Achler
2002-11-25 19:10 ` Zwane Mwaikambo
` (2 more replies)
0 siblings, 3 replies; 4+ messages in thread
From: Ofer Achler @ 2002-11-25 18:37 UTC (permalink / raw)
To: linux-sound
I have a couple of old PII HP vectra machines with this sound card.
(Redhat 8.0)
Sndconfig will see it but the kernel module will not admit that the card
exists:
Nov 25 10:32:19 newthird kernel: ad1848/cs4248 codec driver Copyright
(C) by Hannu Savolainen 1993-1996
Nov 25 10:32:19 newthird kernel: ad1848: No ISAPnP cards found, trying
standard ones...
I tried to manually set the configuration via /proc/isapnp and set the
module parameters by hand via insmod (insmod ad1848 ioS4 irq=5 dma=1
dma2=3), it doesnt work.
Tried via sndconfig, still doesnt work...
Any ideas?
Here's the current output (after manually making the card activate in
isapnp) of /proc/isapnp:
Card 1 'AZT1008:AZT1008 PnP SOUND DEVICE' PnP version 1.0 Product
version 0.3
Logical device 0 'AZT0500:IDE CDROM DISABLED'
Supported registers 0x2
Device is not active
Resources 0
Priority preferred
Port 0x0-0x0, align 0x7, size 0x0, 16-bit address decoding
Port 0x0-0x0, align 0x1, size 0x0, 16-bit address decoding
IRQ <none> High-Edge
Logical device 1 'AZT1008:AUDIO'
Supported registers 0x2
Device is active
Active port 0x220,0x388,0x534
Active IRQ 5 [0x2]
Active DMA 1,3
Resources 0
Priority preferred
Port 0x220-0x220, align 0xf, size 0x10, 16-bit address decoding
Port 0x388-0x388, align 0x7, size 0x8, 16-bit address decoding
Port 0x534-0x534, align 0x3, size 0x4, 16-bit address decoding
IRQ 5 High-Edge
DMA 1 8-bit byte-count compatible
DMA 3 8-bit byte-count compatible
Alternate resources 0:1
Priority acceptable
Port 0x220-0x240, align 0x1f, size 0x10, 16-bit address decoding
Port 0x388-0x388, align 0x7, size 0x8, 16-bit address decoding
Port 0x534-0x608, align 0xd3, size 0x4, 16-bit address decoding
IRQ 5,2/9,10 High-Edge
DMA 0,1,3 8-bit byte-count compatible
DMA 0,1,3 8-bit byte-count compatible
Alternate resources 0:2
^ permalink raw reply [flat|nested] 4+ messages in thread
* Re: AZT1008 on HP Vectra VL6
2002-11-25 18:37 AZT1008 on HP Vectra VL6 Ofer Achler
@ 2002-11-25 19:10 ` Zwane Mwaikambo
2002-11-26 7:07 ` Ofer Achler
2002-11-27 0:55 ` Zwane Mwaikambo
2 siblings, 0 replies; 4+ messages in thread
From: Zwane Mwaikambo @ 2002-11-25 19:10 UTC (permalink / raw)
To: linux-sound
On Mon, 25 Nov 2002, Ofer Achler wrote:
> I have a couple of old PII HP vectra machines with this sound card.
>
> (Redhat 8.0)
> Sndconfig will see it but the kernel module will not admit that the card
> exists:
> Nov 25 10:32:19 newthird kernel: ad1848/cs4248 codec driver Copyright
> (C) by Hannu Savolainen 1993-1996
> Nov 25 10:32:19 newthird kernel: ad1848: No ISAPnP cards found, trying
> standard ones...
You're sure it can be supported by ad1848?
> Here's the current output (after manually making the card activate in
> isapnp) of /proc/isapnp:
>
> Card 1 'AZT1008:AZT1008 PnP SOUND DEVICE' PnP version 1.0 Product
> version 0.3
Might be a simple matter of ISA pnp ids, but then again the ad1848 probe
should have picked it up regardless. What does /proc/ioports and
/proc/interrupts and dmesg say after the module load?
Zwane
--
function.linuxpower.ca
^ permalink raw reply [flat|nested] 4+ messages in thread
* Re: AZT1008 on HP Vectra VL6
2002-11-25 18:37 AZT1008 on HP Vectra VL6 Ofer Achler
2002-11-25 19:10 ` Zwane Mwaikambo
@ 2002-11-26 7:07 ` Ofer Achler
2002-11-27 0:55 ` Zwane Mwaikambo
2 siblings, 0 replies; 4+ messages in thread
From: Ofer Achler @ 2002-11-26 7:07 UTC (permalink / raw)
To: linux-sound
Zwane Mwaikambo wrote:
> You're sure it can be supported by ad1848?
>
Pretty sure =) as far as i can tell via google (also, sndconfig by
default used ad1848, so it's listed somewhere)
> Might be a simple matter of ISA pnp ids, but then again the ad1848 probe
> should have picked it up regardless. What does /proc/ioports and
> /proc/interrupts and dmesg say after the module load?
first off, when i use sndconfig, this is the error it gives:
sndconfig says:
# /lib/modules/2.4.18-18.8.0/kernel/drivers/sound/ad1848.o:
#
# init_module: No such device
#
# /lib/modules/2.4.18-18.8.0/kernel/drivers/sound/ad1848.o:
#
# insmod /lib/modules/2.4.18-18.8.0/kernel/drivers/sound/ad1848.o
#
# failed
#
# /lib/modules/2.4.18-18.8.0/kernel/drivers/sound/ad1848.o:
#
# insmod sound-slot-0 failed
when i insmod manually:
dmesg says:
ad1848/cs4248 codec driver Copyright (C) by Hannu Savolainen 1993-1996
ad1848: No ISAPnP cards found, trying standard ones...
its not listed under interrupts, but heres the output:
CPU0
0: 46137052 XT-PIC timer
1: 4 XT-PIC keyboard
2: 0 XT-PIC cascade
8: 1 XT-PIC rtc
10: 1130131 XT-PIC usb-uhci, eth1
11: 500694 XT-PIC eth0
14: 44411 XT-PIC ide0
15: 18853 XT-PIC ide1
NMI: 0
ERR: 0
It's not listed under ioports either:
0000-001f : dma1
0020-003f : pic1
0040-005f : timer
0060-006f : keyboard
0070-007f : rtc
0080-008f : dma page reg
00a0-00bf : pic2
00c0-00df : dma2
00f0-00ff : fpu
0170-0177 : ide1
01f0-01f7 : ide0
0213-0213 : isapnp read
0376-0376 : ide1
03c0-03df : vga+
03f6-03f6 : ide0
03f8-03ff : serial(auto)
0a79-0a79 : isapnp write
0cf8-0cff : PCI conf1
8000-803f : Intel Corp. 82371AB/EB/MB PIIX4 ACPI
8800-881f : Intel Corp. 82371AB/EB/MB PIIX4 ACPI
fc00-fc7f : 3Com Corporation 3c900B-TPO [Etherlink XL TPO]
fc00-fc7f : 00:0c.0
fca0-fcbf : Intel Corp. 82371AB/EB/MB PIIX4 USB
fca0-fcbf : usb-uhci
fcd0-fcdf : Intel Corp. 82371AB/EB/MB PIIX4 IDE
fcd0-fcd7 : ide0
fcd8-fcdf : ide1
fce0-fcff : Intel Corp. 82557/8/9 [Ethernet Pro 100]
fce0-fcff : eepro100
Here's the relevant output of lsmod:
ad1848 28588 0 (unused)
sound 74388 0 [ad1848]
soundcore 6532 2 [sound]
Thank you for helping me =) i've been stuck on this for a while now and
i know i've got to be close...
-- Ofer Achler
oachler@ucsd.edu
^ permalink raw reply [flat|nested] 4+ messages in thread
* Re: AZT1008 on HP Vectra VL6
2002-11-25 18:37 AZT1008 on HP Vectra VL6 Ofer Achler
2002-11-25 19:10 ` Zwane Mwaikambo
2002-11-26 7:07 ` Ofer Achler
@ 2002-11-27 0:55 ` Zwane Mwaikambo
2 siblings, 0 replies; 4+ messages in thread
From: Zwane Mwaikambo @ 2002-11-27 0:55 UTC (permalink / raw)
To: linux-sound
Could you please try this? Looking at your ioports it certainly does look
like an WSS compatible card. The patch is against 2.4.20-rc1-ac4 but if
you have trouble applying tell me which kernel you'd like it against.
Cheers,
Zwane
Index: linux-2.4.20-rc1-ac4/drivers/sound/ad1848.c
=================================RCS file: /build/cvsroot/linux-2.4.20-rc1-ac4/drivers/sound/ad1848.c,v
retrieving revision 1.1.1.1
diff -u -r1.1.1.1 ad1848.c
--- linux-2.4.20-rc1-ac4/drivers/sound/ad1848.c 18 Nov 2002 01:39:21 -0000 1.1.1.1
+++ linux-2.4.20-rc1-ac4/drivers/sound/ad1848.c 27 Nov 2002 00:51:51 -0000
@@ -2969,6 +2969,10 @@
ISAPNP_ANY_ID, ISAPNP_ANY_ID,
ISAPNP_VENDOR('Y','M','H'), ISAPNP_FUNCTION(0x0021),
1, 0, 0, 1, 1},
+ {"AZT1008",
+ ISAPNP_ANY_ID, ISAPNP_ANY_ID,
+ ISAPNP_VENDOR('A','Z','T'), ISAPNP_FUNCTION(0x0001),
+ 1, 0, 0, 1, 1},
{0}
};
@@ -2981,6 +2985,8 @@
ISAPNP_VENDOR('C','S','C'), ISAPNP_FUNCTION(0x0100), 0 },
{ ISAPNP_ANY_ID, ISAPNP_ANY_ID,
ISAPNP_VENDOR('Y','M','H'), ISAPNP_FUNCTION(0x0021), 0 },
+ { ISAPNP_ANY_ID, ISAPNP_ANY_ID,
+ ISAPNP_VENDOR('A','Z','T'), ISAPNP_FUNCTION(0x0001), 0 },
{0}
};
--
function.linuxpower.ca
^ permalink raw reply [flat|nested] 4+ messages in thread
end of thread, other threads:[~2002-11-27 0:55 UTC | newest]
Thread overview: 4+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2002-11-25 18:37 AZT1008 on HP Vectra VL6 Ofer Achler
2002-11-25 19:10 ` Zwane Mwaikambo
2002-11-26 7:07 ` Ofer Achler
2002-11-27 0:55 ` Zwane Mwaikambo
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox