SB16

[hcchin@strd.csam.com.my]

Hi all,

    I am still having problems with configuring my SB16 sound card. 
    I am using Slakware with kernal 2.0.30. I compile the kernal with 

    Sound ? M
    support for /dev/dsp and /dev/audio ? Y

    Other I put N. I use the isapnptools_1.17 to configure, I read the 
manual, readme, and HOW-TO, tring a few times. Still unable to setup my 
sound card. 

    (One thing good with Windows'95, the driver is really easy to 
install, linux must improve with these)

    Nottingham said that my dirver(Sound Driver:3.5.4-960630) is the old 
one, will this old one work with SB16? Or how could I get the new sound 
driver? 

    The below that show on my Linux:-

% isapnp /etc/isapnp.conf

Board 1 has Identity d7 00 00 15 f5 24 00 8c 0e:  CTL0024 Serial No 5621 
[checksum d7]
CTL0024/5621[0]{Audio               }: Ports 0x220 0x330 0x388; IRQ5 DMA1 
DMA5 --- Enabled OK

% insmod sound
(I did check sound module was not loaded before this)

% lsmod 

Module:        #pages:  Used by:
sound             10		0
ppp                5		0
slip               2		0
slhc               2	[ppp slip]	0
lp                 2		0

BUT
% cat /dev/sndstat

Sound Driver:3.5.4-960630 (Tue Mar 2 05:22:12 SGT 1999 root,

Config options: 0

Installed drivers: 

Card config: 

Audio devices:

Synth devices: NOT ENABLED IN CONFIG

Midi devices: NOT ENABLED IN CONFIG

Timers:

Mixers:

So I can't use the device, what is going wrong?