Linux SPI subsystem development
 help / color / mirror / Atom feed
* [PATCH v2] spi: mt65xx: add PM QoS support
@ 2025-03-04  2:37 Leilk Liu
  2025-03-11 17:17 ` Mark Brown
  0 siblings, 1 reply; 2+ messages in thread
From: Leilk Liu @ 2025-03-04  2:37 UTC (permalink / raw)
  To: Mark Brown
  Cc: Mark Rutland, Matthias Brugger, devicetree, linux-kernel,
	linux-arm-kernel, linux-spi, linux-mediatek, fparent, Leilk Liu

Enable Quality of Service(QoS) support to speed up interrupt service
routine handle. Sometimes, a gic interrupt will be generated after
SPI transmission, but at this time the CPU is in an idle state and the
processing handler will be very slow. It takes time to exit the idle state
and then become active. This will cause the SPI handler to execute slowly
and cause SPI transfer timeouts.

Signed-off-by: Leilk Liu <leilk.liu@mediatek.com>
---
v2: 
 1. add qos_request description in mtk_spi
---
 drivers/spi/spi-mt65xx.c | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/drivers/spi/spi-mt65xx.c b/drivers/spi/spi-mt65xx.c
index 197bf2dbe5de..4b0a1c0db041 100644
--- a/drivers/spi/spi-mt65xx.c
+++ b/drivers/spi/spi-mt65xx.c
@@ -20,6 +20,7 @@
 #include <linux/spi/spi.h>
 #include <linux/spi/spi-mem.h>
 #include <linux/dma-mapping.h>
+#include <linux/pm_qos.h>
 
 #define SPI_CFG0_REG			0x0000
 #define SPI_CFG1_REG			0x0004
@@ -147,6 +148,7 @@ struct mtk_spi_compatible {
  * @tx_sgl_len:		Size of TX DMA transfer
  * @rx_sgl_len:		Size of RX DMA transfer
  * @dev_comp:		Device data structure
+ * @qos_request:	QoS request
  * @spi_clk_hz:		Current SPI clock in Hz
  * @spimem_done:	SPI-MEM operation completion
  * @use_spimem:		Enables SPI-MEM
@@ -166,6 +168,7 @@ struct mtk_spi {
 	struct scatterlist *tx_sgl, *rx_sgl;
 	u32 tx_sgl_len, rx_sgl_len;
 	const struct mtk_spi_compatible *dev_comp;
+	struct pm_qos_request qos_request;
 	u32 spi_clk_hz;
 	struct completion spimem_done;
 	bool use_spimem;
@@ -356,6 +359,7 @@ static int mtk_spi_hw_init(struct spi_controller *host,
 	struct mtk_chip_config *chip_config = spi->controller_data;
 	struct mtk_spi *mdata = spi_controller_get_devdata(host);
 
+	cpu_latency_qos_update_request(&mdata->qos_request, 500);
 	cpha = spi->mode & SPI_CPHA ? 1 : 0;
 	cpol = spi->mode & SPI_CPOL ? 1 : 0;
 
@@ -459,6 +463,15 @@ static int mtk_spi_prepare_message(struct spi_controller *host,
 	return mtk_spi_hw_init(host, msg->spi);
 }
 
+static int mtk_spi_unprepare_message(struct spi_controller *host,
+				     struct spi_message *message)
+{
+	struct mtk_spi *mdata = spi_controller_get_devdata(host);
+
+	cpu_latency_qos_update_request(&mdata->qos_request, PM_QOS_DEFAULT_VALUE);
+	return 0;
+}
+
 static void mtk_spi_set_cs(struct spi_device *spi, bool enable)
 {
 	u32 reg_val;
@@ -1143,6 +1156,7 @@ static int mtk_spi_probe(struct platform_device *pdev)
 
 	host->set_cs = mtk_spi_set_cs;
 	host->prepare_message = mtk_spi_prepare_message;
+	host->unprepare_message = mtk_spi_unprepare_message;
 	host->transfer_one = mtk_spi_transfer_one;
 	host->can_dma = mtk_spi_can_dma;
 	host->setup = mtk_spi_setup;
@@ -1249,6 +1263,8 @@ static int mtk_spi_probe(struct platform_device *pdev)
 		clk_disable_unprepare(mdata->spi_hclk);
 	}
 
+	cpu_latency_qos_add_request(&mdata->qos_request, PM_QOS_DEFAULT_VALUE);
+
 	if (mdata->dev_comp->need_pad_sel) {
 		if (mdata->pad_num != host->num_chipselect)
 			return dev_err_probe(dev, -EINVAL,
@@ -1292,6 +1308,7 @@ static void mtk_spi_remove(struct platform_device *pdev)
 	struct mtk_spi *mdata = spi_controller_get_devdata(host);
 	int ret;
 
+	cpu_latency_qos_remove_request(&mdata->qos_request);
 	if (mdata->use_spimem && !completion_done(&mdata->spimem_done))
 		complete(&mdata->spimem_done);
 
-- 
2.46.0


^ permalink raw reply related	[flat|nested] 2+ messages in thread

end of thread, other threads:[~2025-03-11 17:17 UTC | newest]

Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2025-03-04  2:37 [PATCH v2] spi: mt65xx: add PM QoS support Leilk Liu
2025-03-11 17:17 ` Mark Brown

This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox