[PATCH] spi: fix typos in comments

[PATCH] spi: fix typos in comments

[Hemanth Selam]

Fix typos in comments, reported by scripts/checkpatch.pl using the
misspelling list in scripts/spelling.txt.  Only touches comments, no code
changes.

Assisted-by: Cursor:claude-opus-5
Signed-off-by: Hemanth Selam <hemanth.selam@gmail.com>
---
 drivers/spi/spi-bcm63xx.c     | 2 +-
 drivers/spi/spi-imx.c         | 2 +-
 drivers/spi/spi-omap2-mcspi.c | 2 +-
 drivers/spi/spi-pic32.c       | 2 +-
 drivers/spi/spi-s3c64xx.c     | 2 +-
 drivers/spi/spi-stm32.c       | 2 +-
 drivers/spi/spi-sun6i.c       | 2 +-
 drivers/spi/spi-xilinx.c      | 2 +-
 8 files changed, 8 insertions(+), 8 deletions(-)

diff --git a/drivers/spi/spi-bcm63xx.c b/drivers/spi/spi-bcm63xx.c
index 1d8e257bad30..3f349c1db581 100644
--- a/drivers/spi/spi-bcm63xx.c
+++ b/drivers/spi/spi-bcm63xx.c
@@ -413,7 +413,7 @@ static irqreturn_t bcm63xx_spi_interrupt(int irq, void *dev_id)
 	struct bcm63xx_spi *bs = spi_controller_get_devdata(host);
 	u8 intr;
 
-	/* Read interupts and clear them immediately */
+	/* Read interrupts and clear them immediately */
 	intr = bcm_spi_readb(bs, SPI_INT_STATUS);
 	bcm_spi_writeb(bs, SPI_INTR_CLEAR_ALL, SPI_INT_STATUS);
 	bcm_spi_writeb(bs, 0, SPI_INT_MASK);
diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c
index 79a6c1a60b0a..6f9686df0486 100644
--- a/drivers/spi/spi-imx.c
+++ b/drivers/spi/spi-imx.c
@@ -673,7 +673,7 @@ static int mx51_ecspi_prepare_message(struct spi_imx_data *spi_imx,
 	 * propagate into the hardware. It takes exactly one tick of the
 	 * SCLK clock, but we will wait two SCLK clock just to be sure. The
 	 * effect of the delay it takes for the hardware to apply changes
-	 * is noticable if the SCLK clock run very slow. In such a case, if
+	 * is noticeable if the SCLK clock run very slow. In such a case, if
 	 * the polarity of SCLK should be inverted, the GPIO ChipSelect might
 	 * be asserted before the SCLK polarity changes, which would disrupt
 	 * the SPI communication as the device on the other end would consider
diff --git a/drivers/spi/spi-omap2-mcspi.c b/drivers/spi/spi-omap2-mcspi.c
index a3355147f5de..90f3990e0060 100644
--- a/drivers/spi/spi-omap2-mcspi.c
+++ b/drivers/spi/spi-omap2-mcspi.c
@@ -1244,7 +1244,7 @@ static int omap2_mcspi_transfer_one(struct spi_controller *ctlr,
 		omap2_mcspi_set_fifo(spi, t, 0);
 
 out:
-	/* Restore defaults if they were overriden */
+	/* Restore defaults if they were overridden */
 	if (par_override) {
 		par_override = 0;
 		status = omap2_mcspi_setup_transfer(spi, NULL);
diff --git a/drivers/spi/spi-pic32.c b/drivers/spi/spi-pic32.c
index 972128271e4b..8363bc873b03 100644
--- a/drivers/spi/spi-pic32.c
+++ b/drivers/spi/spi-pic32.c
@@ -53,7 +53,7 @@ struct pic32_spi_regs {
 #define  TX_FIFO_ALL_EMPTY	0 /* completely empty */
 #define  TX_FIFO_EMPTY		1 /* empty */
 #define  TX_FIFO_HALF_EMPTY	2 /* empty by half or more */
-#define  TX_FIFO_NOT_FULL	3 /* atleast one empty */
+#define  TX_FIFO_NOT_FULL	3 /* at least one empty */
 
 #define CTRL_MSTEN	BIT(5) /* enable master mode */
 #define CTRL_CKP	BIT(6) /* active low */
diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
index 8d4120cf9df1..3546414dfc70 100644
--- a/drivers/spi/spi-s3c64xx.c
+++ b/drivers/spi/spi-s3c64xx.c
@@ -661,7 +661,7 @@ static int s3c64xx_wait_for_pio(struct s3c64xx_spi_driver_data *sdd,
 	 * loops = length / max fifo size (calculated by using the
 	 * fifo mask).
 	 * For any size less than the fifo size the below code is
-	 * executed atleast once.
+	 * executed at least once.
 	 */
 	loops = xfer->len / sdd->fifo_depth;
 	buf = xfer->rx_buf;
diff --git a/drivers/spi/spi-stm32.c b/drivers/spi/spi-stm32.c
index be88e62075af..5f5c43ae5096 100644
--- a/drivers/spi/spi-stm32.c
+++ b/drivers/spi/spi-stm32.c
@@ -515,7 +515,7 @@ static int stm32h7_spi_get_bpw_mask(struct stm32_spi *spi)
 
 	/*
 	 * The most significant bit at DSIZE bit field is reserved when the
-	 * maximum data size of periperal instances is limited to 16-bit
+	 * maximum data size of peripheral instances is limited to 16-bit
 	 */
 	stm32_spi_set_bits(spi, STM32H7_SPI_CFG1, STM32H7_SPI_CFG1_DSIZE);
 
diff --git a/drivers/spi/spi-sun6i.c b/drivers/spi/spi-sun6i.c
index 4631e9c7ca1d..6b7a05dd0de8 100644
--- a/drivers/spi/spi-sun6i.c
+++ b/drivers/spi/spi-sun6i.c
@@ -386,7 +386,7 @@ static int sun6i_spi_transfer_one(struct spi_controller *host,
 		 * SPI_CLK = MOD_CLK / (2 ^ cdr)
 		 * Or we can use CDR2, which is calculated with the formula:
 		 * SPI_CLK = MOD_CLK / (2 * (cdr + 1))
-		 * Wether we use the former or the latter is set through the
+		 * Whether we use the former or the latter is set through the
 		 * DRS bit.
 		 *
 		 * First try CDR2, and if we can't reach the expected
diff --git a/drivers/spi/spi-xilinx.c b/drivers/spi/spi-xilinx.c
index dc1e968659e1..df4ea99a5427 100644
--- a/drivers/spi/spi-xilinx.c
+++ b/drivers/spi/spi-xilinx.c
@@ -460,7 +460,7 @@ static int xilinx_spi_probe(struct platform_device *pdev)
 	host->num_chipselect = num_cs;
 
 	/*
-	 * Detect endianess on the IP via loop bit in CR. Detection
+	 * Detect endianness on the IP via loop bit in CR. Detection
 	 * must be done before reset is sent because incorrect reset
 	 * value generates error interrupt.
 	 * Setup little endian helper functions first and try to use them
-- 
2.48.1

Re: [PATCH] spi: fix typos in comments

[Mark Brown]

On Fri, 04 Sep 2026 16:34:16 +0530, Hemanth Selam wrote:
> spi: fix typos in comments

Applied to

   https://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git for-7.4

Thanks!

[1/1] spi: fix typos in comments
      https://git.kernel.org/broonie/spi/c/98477036fc35

All being well this means that it will be integrated into the linux-next
tree (usually sometime in the next 24 hours) and sent to Linus during
the next merge window (or sooner if it is a bug fix), however if
problems are discovered then the patch may be dropped or reverted.

You may get further e-mails resulting from automated or manual testing
and review of the tree, please engage with people reporting problems and
send followup patches addressing any issues that are reported if needed.

If any updates are required or you are submitting further changes they
should be sent as incremental updates against current git, existing
patches will not be replaced.

Please add any relevant lists and maintainers to the CCs when replying
to this mail.

Thanks,
Mark