Re: [PATCH v1] spi: geni-qcom: Fix CPHA and CPOL mode change detection

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 3/16/26 2:23 PM, Maramaina Naresh wrote:
> setup_fifo_params computes mode_changed from spi->mode flags but tests
> it against SE_SPI_CPHA and SE_SPI_CPOL, which are register offsets,
> not SPI mode bits. This causes CPHA and CPOL updates to be skipped
> on mode switches, leaving the controller with stale clock phase
> and polarity settings.
> 
> Fix this by using SPI_CPHA and SPI_CPOL to detect mode changes before
> updating the corresponding registers.
> 
> Fixes: 781c3e71c94c ("spi: spi-geni-qcom: rework setup_fifo_params")
> Signed-off-by: Maramaina Naresh <naresh.maramaina@oss.qualcomm.com>
> ---
> This patch fixes SPI mode change detection in the spi-geni-qcom driver.
> 
> setup_fifo_params compared spi->mode against SE_SPI_CPHA/SE_SPI_CPOL,
> which are register offsets instead of SPI_CPHA/SPI_CPOL mode bits.
> This could skip CPHA/CPOL updates on mode switches and leave stale
> clock configuration.
> 
> This is a single-patch series.

Note this ""cover letter"" is unnecessary for such single-patch

Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>

Konrad