[PATCH 4/5] power: supply: axp20x_battery: Update temp sensor for AXP717 from device tree

[Chris Morgan <macroalpha82@gmail.com>]

From: Chris Morgan <macromorgan@hotmail.com>

Allow a boolean property of "x-powers,no-thermistor" to specify devices
where the ts pin is not connected to anything. This works around an
issue found with some devices where the efuse is not programmed
correctly from the factory or when the register gets set erroneously.

Signed-off-by: Chris Morgan <macromorgan@hotmail.com>
---
 drivers/power/supply/axp20x_battery.c | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)

diff --git a/drivers/power/supply/axp20x_battery.c b/drivers/power/supply/axp20x_battery.c
index 3c3158f31a48..345a1bbe50ad 100644
--- a/drivers/power/supply/axp20x_battery.c
+++ b/drivers/power/supply/axp20x_battery.c
@@ -89,6 +89,8 @@
 #define AXP717_BAT_CC_MIN_UA		0
 #define AXP717_BAT_CC_MAX_UA		3008000
 
+#define AXP717_TS_PIN_DISABLE		BIT(4)
+
 struct axp20x_batt_ps;
 
 struct axp_data {
@@ -117,6 +119,7 @@ struct axp20x_batt_ps {
 	/* Maximum constant charge current */
 	unsigned int max_ccc;
 	const struct axp_data	*data;
+	bool ts_disable;
 };
 
 static int axp20x_battery_get_max_voltage(struct axp20x_batt_ps *axp20x_batt,
@@ -984,6 +987,22 @@ static void axp717_set_battery_info(struct platform_device *pdev,
 	int ccc = info->constant_charge_current_max_ua;
 	int val;
 
+	axp_batt->ts_disable = (device_property_read_bool(axp_batt->dev,
+							  "x-powers,no-thermistor"));
+
+	/*
+	 * Under rare conditions an incorrectly programmed efuse for
+	 * the temp sensor on the PMIC may trigger a fault condition.
+	 * Allow users to hard-code if the ts pin is not used to work
+	 * around this problem.
+	 */
+	if (axp_batt->ts_disable) {
+		regmap_update_bits(axp_batt->regmap,
+				   AXP717_TS_PIN_CFG,
+				   AXP717_TS_PIN_DISABLE,
+				   AXP717_TS_PIN_DISABLE);
+	}
+
 	if (vmin > 0 && axp717_set_voltage_min_design(axp_batt, vmin))
 		dev_err(&pdev->dev,
 			"couldn't set voltage_min_design\n");
-- 
2.43.0