* Re: [PATCH 5.15 00/55] 5.15.182-rc1 review [not found] <20250507183759.048732653@linuxfoundation.org> @ 2025-05-08 9:44 ` Jon Hunter 2025-05-08 11:23 ` Greg Kroah-Hartman 0 siblings, 1 reply; 3+ messages in thread From: Jon Hunter @ 2025-05-08 9:44 UTC (permalink / raw) To: Greg Kroah-Hartman, stable Cc: patches, linux-kernel, torvalds, akpm, linux, shuah, patches, lkft-triage, pavel, f.fainelli, sudipm.mukherjee, srw, rwarsow, conor, hargar, broonie, linux-tegra@vger.kernel.org Hi Greg, On 07/05/2025 19:39, Greg Kroah-Hartman wrote: > This is the start of the stable review cycle for the 5.15.182 release. > There are 55 patches in this series, all will be posted as a response > to this one. If anyone has any issues with these being applied, please > let me know. > > Responses should be made by Fri, 09 May 2025 18:37:41 +0000. > Anything received after that time might be too late. > > The whole patch series can be found in one patch at: > https://www.kernel.org/pub/linux/kernel/v5.x/stable-review/patch-5.15.182-rc1.gz > or in the git tree and branch at: > git://git.kernel.org/pub/scm/linux/kernel/git/stable/linux-stable-rc.git linux-5.15.y > and the diffstat can be found below. > > thanks, > > greg k-h > > ------------- > Pseudo-Shortlog of commits: ... > Stephan Gerhold <stephan.gerhold@linaro.org> > serial: msm: Configure correct working mode before starting earlycon The above commit is breaking the build for ARM64 and I am seeing the following build error ... drivers/tty/serial/msm_serial.c: In function ‘msm_serial_early_console_setup_dm’: drivers/tty/serial/msm_serial.c:1737:34: error: ‘MSM_UART_CR_CMD_RESET_RX’ undeclared (first use in this function); did you mean ‘UART_CR_CMD_RESET_RX’? 1737 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_RX, MSM_UART_CR); | ^~~~~~~~~~~~~~~~~~~~~~~~ | UART_CR_CMD_RESET_RX drivers/tty/serial/msm_serial.c:1737:34: note: each undeclared identifier is reported only once for each function it appears in drivers/tty/serial/msm_serial.c:1737:60: error: ‘MSM_UART_CR’ undeclared (first use in this function); did you mean ‘UART_CR’? 1737 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_RX, MSM_UART_CR); | ^~~~~~~~~~~ | UART_CR drivers/tty/serial/msm_serial.c:1738:34: error: ‘MSM_UART_CR_CMD_RESET_TX’ undeclared (first use in this function); did you mean ‘UART_CR_CMD_RESET_TX’? 1738 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_TX, MSM_UART_CR); | ^~~~~~~~~~~~~~~~~~~~~~~~ | UART_CR_CMD_RESET_TX CC drivers/ata/libata-transport.o drivers/tty/serial/msm_serial.c:1739:34: error: ‘MSM_UART_CR_TX_ENABLE’ undeclared (first use in this function); did you mean ‘UART_CR_TX_ENABLE’? 1739 | msm_write(&device->port, MSM_UART_CR_TX_ENABLE, MSM_UART_CR); | ^~~~~~~~~~~~~~~~~~~~~ | UART_CR_TX_ENABLE After reverting this, the build is passing again. Thanks! Jon -- nvpublic ^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: [PATCH 5.15 00/55] 5.15.182-rc1 review 2025-05-08 9:44 ` [PATCH 5.15 00/55] 5.15.182-rc1 review Jon Hunter @ 2025-05-08 11:23 ` Greg Kroah-Hartman 2025-05-08 12:22 ` Jon Hunter 0 siblings, 1 reply; 3+ messages in thread From: Greg Kroah-Hartman @ 2025-05-08 11:23 UTC (permalink / raw) To: Jon Hunter Cc: stable, patches, linux-kernel, torvalds, akpm, linux, shuah, patches, lkft-triage, pavel, f.fainelli, sudipm.mukherjee, srw, rwarsow, conor, hargar, broonie, linux-tegra@vger.kernel.org On Thu, May 08, 2025 at 10:44:45AM +0100, Jon Hunter wrote: > Hi Greg, > > On 07/05/2025 19:39, Greg Kroah-Hartman wrote: > > This is the start of the stable review cycle for the 5.15.182 release. > > There are 55 patches in this series, all will be posted as a response > > to this one. If anyone has any issues with these being applied, please > > let me know. > > > > Responses should be made by Fri, 09 May 2025 18:37:41 +0000. > > Anything received after that time might be too late. > > > > The whole patch series can be found in one patch at: > > https://www.kernel.org/pub/linux/kernel/v5.x/stable-review/patch-5.15.182-rc1.gz > > or in the git tree and branch at: > > git://git.kernel.org/pub/scm/linux/kernel/git/stable/linux-stable-rc.git linux-5.15.y > > and the diffstat can be found below. > > > > thanks, > > > > greg k-h > > > > ------------- > > Pseudo-Shortlog of commits: > > ... > > Stephan Gerhold <stephan.gerhold@linaro.org> > > serial: msm: Configure correct working mode before starting earlycon > > The above commit is breaking the build for ARM64 and I am seeing > the following build error ... > > drivers/tty/serial/msm_serial.c: In function ‘msm_serial_early_console_setup_dm’: > drivers/tty/serial/msm_serial.c:1737:34: error: ‘MSM_UART_CR_CMD_RESET_RX’ undeclared (first use in this function); did you mean ‘UART_CR_CMD_RESET_RX’? > 1737 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_RX, MSM_UART_CR); > | ^~~~~~~~~~~~~~~~~~~~~~~~ > | UART_CR_CMD_RESET_RX > drivers/tty/serial/msm_serial.c:1737:34: note: each undeclared identifier is reported only once for each function it appears in > drivers/tty/serial/msm_serial.c:1737:60: error: ‘MSM_UART_CR’ undeclared (first use in this function); did you mean ‘UART_CR’? > 1737 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_RX, MSM_UART_CR); > | ^~~~~~~~~~~ > | UART_CR > drivers/tty/serial/msm_serial.c:1738:34: error: ‘MSM_UART_CR_CMD_RESET_TX’ undeclared (first use in this function); did you mean ‘UART_CR_CMD_RESET_TX’? > 1738 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_TX, MSM_UART_CR); > | ^~~~~~~~~~~~~~~~~~~~~~~~ > | UART_CR_CMD_RESET_TX > CC drivers/ata/libata-transport.o > drivers/tty/serial/msm_serial.c:1739:34: error: ‘MSM_UART_CR_TX_ENABLE’ undeclared (first use in this function); did you mean ‘UART_CR_TX_ENABLE’? > 1739 | msm_write(&device->port, MSM_UART_CR_TX_ENABLE, MSM_UART_CR); > | ^~~~~~~~~~~~~~~~~~~~~ > | UART_CR_TX_ENABLE > > > After reverting this, the build is passing again. Thanks, commit is now dropped. Odd it didn't show up on my arm64 allmodconfig builds :( greg k-h ^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: [PATCH 5.15 00/55] 5.15.182-rc1 review 2025-05-08 11:23 ` Greg Kroah-Hartman @ 2025-05-08 12:22 ` Jon Hunter 0 siblings, 0 replies; 3+ messages in thread From: Jon Hunter @ 2025-05-08 12:22 UTC (permalink / raw) To: Greg Kroah-Hartman Cc: stable, patches, linux-kernel, torvalds, akpm, linux, shuah, patches, lkft-triage, pavel, f.fainelli, sudipm.mukherjee, srw, rwarsow, conor, hargar, broonie, linux-tegra@vger.kernel.org On 08/05/2025 12:23, Greg Kroah-Hartman wrote: > On Thu, May 08, 2025 at 10:44:45AM +0100, Jon Hunter wrote: >> Hi Greg, >> >> On 07/05/2025 19:39, Greg Kroah-Hartman wrote: >>> This is the start of the stable review cycle for the 5.15.182 release. >>> There are 55 patches in this series, all will be posted as a response >>> to this one. If anyone has any issues with these being applied, please >>> let me know. >>> >>> Responses should be made by Fri, 09 May 2025 18:37:41 +0000. >>> Anything received after that time might be too late. >>> >>> The whole patch series can be found in one patch at: >>> https://www.kernel.org/pub/linux/kernel/v5.x/stable-review/patch-5.15.182-rc1.gz >>> or in the git tree and branch at: >>> git://git.kernel.org/pub/scm/linux/kernel/git/stable/linux-stable-rc.git linux-5.15.y >>> and the diffstat can be found below. >>> >>> thanks, >>> >>> greg k-h >>> >>> ------------- >>> Pseudo-Shortlog of commits: >> >> ... >>> Stephan Gerhold <stephan.gerhold@linaro.org> >>> serial: msm: Configure correct working mode before starting earlycon >> >> The above commit is breaking the build for ARM64 and I am seeing >> the following build error ... >> >> drivers/tty/serial/msm_serial.c: In function ‘msm_serial_early_console_setup_dm’: >> drivers/tty/serial/msm_serial.c:1737:34: error: ‘MSM_UART_CR_CMD_RESET_RX’ undeclared (first use in this function); did you mean ‘UART_CR_CMD_RESET_RX’? >> 1737 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_RX, MSM_UART_CR); >> | ^~~~~~~~~~~~~~~~~~~~~~~~ >> | UART_CR_CMD_RESET_RX >> drivers/tty/serial/msm_serial.c:1737:34: note: each undeclared identifier is reported only once for each function it appears in >> drivers/tty/serial/msm_serial.c:1737:60: error: ‘MSM_UART_CR’ undeclared (first use in this function); did you mean ‘UART_CR’? >> 1737 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_RX, MSM_UART_CR); >> | ^~~~~~~~~~~ >> | UART_CR >> drivers/tty/serial/msm_serial.c:1738:34: error: ‘MSM_UART_CR_CMD_RESET_TX’ undeclared (first use in this function); did you mean ‘UART_CR_CMD_RESET_TX’? >> 1738 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_TX, MSM_UART_CR); >> | ^~~~~~~~~~~~~~~~~~~~~~~~ >> | UART_CR_CMD_RESET_TX >> CC drivers/ata/libata-transport.o >> drivers/tty/serial/msm_serial.c:1739:34: error: ‘MSM_UART_CR_TX_ENABLE’ undeclared (first use in this function); did you mean ‘UART_CR_TX_ENABLE’? >> 1739 | msm_write(&device->port, MSM_UART_CR_TX_ENABLE, MSM_UART_CR); >> | ^~~~~~~~~~~~~~~~~~~~~ >> | UART_CR_TX_ENABLE >> >> >> After reverting this, the build is passing again. > > Thanks, commit is now dropped. Odd it didn't show up on my arm64 > allmodconfig builds :( I saw this just building the stock ARM64 defconfig. Jon -- nvpublic ^ permalink raw reply [flat|nested] 3+ messages in thread
end of thread, other threads:[~2025-05-08 12:23 UTC | newest]
Thread overview: 3+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
[not found] <20250507183759.048732653@linuxfoundation.org>
2025-05-08 9:44 ` [PATCH 5.15 00/55] 5.15.182-rc1 review Jon Hunter
2025-05-08 11:23 ` Greg Kroah-Hartman
2025-05-08 12:22 ` Jon Hunter
This is a public inbox, see mirroring instructions for how to clone and mirror all data and code used for this inbox