[PATCH AUTOSEL 4.19 003/172] ASoC: tegra: tegra_wm8903: Support nvidia, headset property

[PATCH AUTOSEL 4.19 003/172] ASoC: tegra: tegra_wm8903: Support nvidia, headset property

[Sasha Levin]

From: Dmitry Osipenko <digetx@gmail.com>

[ Upstream commit 3ef9d5073b552d56bd6daf2af1e89b7e8d4df183 ]

The microphone-jack state needs to be masked in a case of a 4-pin jack
when microphone and ground pins are shorted. Presence of nvidia,headset
tells that WM8903 CODEC driver should mask microphone's status if short
circuit is detected, i.e headphones are inserted.

Signed-off-by: Dmitry Osipenko <digetx@gmail.com>
Link: https://lore.kernel.org/r/20200330204011.18465-3-digetx@gmail.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 sound/soc/tegra/tegra_wm8903.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/sound/soc/tegra/tegra_wm8903.c b/sound/soc/tegra/tegra_wm8903.c
index 69bc9461974b..301850df368d 100644
--- a/sound/soc/tegra/tegra_wm8903.c
+++ b/sound/soc/tegra/tegra_wm8903.c
@@ -173,6 +173,7 @@ static int tegra_wm8903_init(struct snd_soc_pcm_runtime *rtd)
 	struct snd_soc_component *component = codec_dai->component;
 	struct snd_soc_card *card = rtd->card;
 	struct tegra_wm8903 *machine = snd_soc_card_get_drvdata(card);
+	int shrt = 0;
 
 	if (gpio_is_valid(machine->gpio_hp_det)) {
 		tegra_wm8903_hp_jack_gpio.gpio = machine->gpio_hp_det;
@@ -185,12 +186,15 @@ static int tegra_wm8903_init(struct snd_soc_pcm_runtime *rtd)
 					&tegra_wm8903_hp_jack_gpio);
 	}
 
+	if (of_property_read_bool(card->dev->of_node, "nvidia,headset"))
+		shrt = SND_JACK_MICROPHONE;
+
 	snd_soc_card_jack_new(rtd->card, "Mic Jack", SND_JACK_MICROPHONE,
 			      &tegra_wm8903_mic_jack,
 			      tegra_wm8903_mic_jack_pins,
 			      ARRAY_SIZE(tegra_wm8903_mic_jack_pins));
 	wm8903_mic_detect(component, &tegra_wm8903_mic_jack, SND_JACK_MICROPHONE,
-				0);
+				shrt);
 
 	snd_soc_dapm_force_enable_pin(&card->dapm, "MICBIAS");
 
-- 
2.25.1

[PATCH AUTOSEL 4.19 105/172] arm64: tegra: Fix ethernet phy-mode for Jetson Xavier

[Sasha Levin]

From: Jon Hunter <jonathanh-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>

[ Upstream commit bba25915b172c72f6fa635f091624d799e3c9cae ]

The 'phy-mode' property is currently defined as 'rgmii' for Jetson
Xavier. This indicates that the RGMII RX and TX delays are set by the
MAC and the internal delays set by the PHY are not used.

If the Marvell PHY driver is enabled, such that it is used and not the
generic PHY, ethernet failures are seen (DHCP is failing to obtain an
IP address) and this is caused because the Marvell PHY driver is
disabling the internal RX and TX delays. For Jetson Xavier the internal
PHY RX and TX delay should be used and so fix this by setting the
'phy-mode' to 'rgmii-id' and not 'rgmii'.

Fixes: f89b58ce71a9 ("arm64: tegra: Add ethernet controller on Tegra194")
Signed-off-by: Jon Hunter <jonathanh-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
Signed-off-by: Thierry Reding <treding-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
Signed-off-by: Sasha Levin <sashal-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>
---
 arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi b/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi
index 57d3f00464ce..7352954e12be 100644
--- a/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi
+++ b/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi
@@ -32,7 +32,7 @@ ethernet@2490000 {
 
 			phy-reset-gpios = <&gpio TEGRA194_MAIN_GPIO(G, 5) GPIO_ACTIVE_LOW>;
 			phy-handle = <&phy>;
-			phy-mode = "rgmii";
+			phy-mode = "rgmii-id";
 
 			mdio {
 				#address-cells = <1>;
-- 
2.25.1