[Bug 221699] New: PCIe link drops during GPU BAR2 init — Minisforum DEG2 eGPU dock over Thunderbolt 4

[Bug 221699] New: PCIe link drops during GPU BAR2 init — Minisforum DEG2 eGPU dock over Thunderbolt 4

[bugzilla-daemon]

https://bugzilla.kernel.org/show_bug.cgi?id=221699

            Bug ID: 221699
           Summary: PCIe link drops during GPU BAR2 init — Minisforum DEG2
                    eGPU dock over Thunderbolt 4
           Product: Drivers
           Version: 2.5
          Hardware: All
                OS: Linux
            Status: NEW
          Severity: normal
          Priority: P3
         Component: USB
          Assignee: drivers_usb@kernel-bugs.kernel.org
          Reporter: artiom@flexlabs.org
        Regression: No

Created attachment 310385
  --> https://bugzilla.kernel.org/attachment.cgi?id=310385&action=edit
dmesg logs: Connecting the dock with the GPU attached, USB and NVMe
disconnected, using Nvidia driver

An RTX 3080 Ti connected via a Minisforum DEG2 Thunderbolt 5 eGPU dock to a
Thunderbolt-4 laptop running Linux enumerates correctly over the PCIe tunnel,
but the PCIe link then dies roughly 8–10 seconds later, while the GPU driver is
in its early BAR2 (instance-memory / page-table aperture) initialization phase.
This reproduces under both the proprietary NVIDIA driver and the in-tree
nouveau driver, which strongly suggests the fault is below the driver layer —
in the Thunderbolt/PCIe tunnel itself (the kernel thunderbolt/pciehp path, the
dock firmware, or the Intel Barlow Ridge-class controller).

The same dock, cable, and GPU work without issue under Windows, including under
a sustained 3D stress test.

## System configuration:

* Laptop: Lenovo ThinkPad, model 21VVCTO1WW, BIOS N4QET33W (1.12)
* CPU/platform: Intel Panther Lake, integrated Arc B390 iGPU (xe driver)
* Thunderbolt host: Intel Panther Lake Thunderbolt 4 NHI (USB4)
* OS / kernel: Fedora 44, 7.0.13-200.fc44.x86_64
* eGPU dock: Minisforum DEG2 in Thunderbolt mode. Enumerates over Thunderbolt
as "Micro Computer (HK) Tech. Ltd. TBGAA"
* GPU: NVIDIA RTX 3080 Ti
* Cable: DEG2-supplied TB5 cable (confirmed functional under Windows 3D load)
* Dock PSU: Corsair SF850
* Drivers tested: NVIDIA open kernel module 595.80 (GSP-based); nouveau
(in-tree, GSP/r535 path, firmware RM version 570.144)


## Reproducible symptom

1. Dock connected (reproduces on both cold-plug and hot-plug).
2. Thunderbolt/USB4 link authorizes; PCIe hotplug bridge reports pciehp:
Slot(10-2): Card present → Link Up.
3. Full PCIe enumeration succeeds: the Intel switch, the GPU (82:00.0) and its
audio function (82:00.1) appear, and BARs are assigned (BAR1 prefetchable 256
MB, BAR3 prefetchable 32 MB, BAR0 16 MB, etc.).
4. The GPU driver begins bring-up and reaches BAR2 initialization.
5. Within 5 seconds after connecting the cable, the OS becomes visually
unresponsive
6. Approximately 8–10 seconds after Link Up, the GPU stops responding on the
PCIe link:

  * NVIDIA driver (~10 s): NVRM: Xid (PCI:0000:82:00): 79, GPU has fallen off
the bus, immediately followed by BAR2 setup failing as a consequence —
kbusInitVirtualBar2_HAL ... kern_bus.c:469, kbusInitBar2_HAL ...
kern_bus_gm107.c:332 — then pciehp: Slot(10-2): Link Down and RM resource-leak
assertions during teardown.
  * nouveau driver (~8 s): the driver is actively performing BAR2 bring-up
(gf100_bar_oneinit_bar → nvkm_vmm_boot → nvkm_bar_bar2_init/r535_bar_bar2_init)
when MMIO accesses begin returning all-ones: nouveau: timer: stalled at
ffffffffffffffff in g84_bar_flush/tu102_vmm_flush, looping for several seconds,
then pciehp: pcie_do_write_cmd: no response from device.

7. Unplugging the dock immediately restores stability; replugging reproduces
the fault. Leaving it plugged keeps the system unresponsive, and it shortly
resets within 5 more seconds or so.

The key shared detail: under both drivers, the device falls off the bus during
early BAR2 initialization — NVIDIA's "fallen off the bus" detection and its
BAR2-init failure are interleaved in the same instant, and nouveau's hang is
literally inside the BAR2 flush. The two drivers share no relevant code here,
so this points away from a driver bug.

## Directly observed evidence

* Cross-driver reproduction at the same stage. Two independent drivers fail at
BAR2 init (function names above), with the link dropping ~8–10 s after
enumeration.
* GPU-presence is the determining variable. With the GPU removed from the riser
and only the dock's onboard NVMe SSD connected, the dock ran stably for ~37 s
(49 s → 86 s, ended by manual disconnect) with clean USB/UAS/SCSI enumeration
and no link drop or errors. The fault appears only when the GPU is present and
BAR2 init begins.
* Windows is unaffected. The same dock + cable + GPU sustained a 3D stress test
under Windows on a different host with no link loss, indicating the GPU, cable,
dock power delivery, and dock hardware are functional.

## Kernel parameters tried

* Default parameters: GPU enumerates fully, link dies at BAR2 init as described
above. (This is the failure being reported.)
* pcie_aspm=off: system boots, but the eGPU's PCIe link does not initialize —
the GPU does not reach the enumeration/BAR2 stage at all. This is a different
behavior from the default-parameter crash, not a reproduction of it.

## Other potential factors

* GPU, cable, dock power delivery: Functional, tested by sustained 3D stress
test on Windows
* BIOS configuration: All thunderbolt configuration turned on, including PCIe
tunneling
* DEG2 configuration: Verified that the mode switch is set to Thunderbolt
(tested with the Oculink setting, just to be safe, but also TB mode confirmed
working on Windows)

## Suspected root-cause area (hypothesis)

* A kernel thunderbolt/pciehp interaction specific to a discrete GPU's large
memory-mapped BAR2 traffic tunneled through this Barlow Ridge-class controller
over a TB4 host.
* DEG2 / controller firmware failing to sustain the PCIe tunnel once large
BAR-mapped GPU MMIO begins (vs. the lighter NVMe/USB traffic that runs fine).
* A Linux-specific gap in tunnel setup/maintenance that Windows handles
differently (Windows is unaffected under heavier load).

## Attached log files:

1. GPU only: Connecting the dock with the GPU attached, USB and NVMe
disconnected, using Nvidia driver
2. NVMe only: Connecting the dock with GPU removed, only NVMe drive attached
3. Nouveau driver: Connected the dock with the nvidia driver disabled in grub,
using Nouveau driver instead

-- 
You may reply to this email to add a comment.

You are receiving this mail because:
You are watching the assignee of the bug.

[Bug 221699] PCIe link drops during GPU BAR2 init — Minisforum DEG2 eGPU dock over Thunderbolt 4

[bugzilla-daemon]

https://bugzilla.kernel.org/show_bug.cgi?id=221699

--- Comment #1 from Artiom (artiom@flexlabs.org) ---
Created attachment 310386
  --> https://bugzilla.kernel.org/attachment.cgi?id=310386&action=edit
dmesg logs: Connecting the dock with GPU removed, only NVMe drive attached

-- 
You may reply to this email to add a comment.

You are receiving this mail because:
You are watching the assignee of the bug.

[Bug 221699] PCIe link drops during GPU BAR2 init — Minisforum DEG2 eGPU dock over Thunderbolt 4

[bugzilla-daemon]

https://bugzilla.kernel.org/show_bug.cgi?id=221699

--- Comment #2 from Artiom (artiom@flexlabs.org) ---
Created attachment 310387
  --> https://bugzilla.kernel.org/attachment.cgi?id=310387&action=edit
dmesg logs: Connected the dock with the nvidia driver disabled in grub, using
Nouveau driver instead

-- 
You may reply to this email to add a comment.

You are receiving this mail because:
You are watching the assignee of the bug.