Re: [PATCH 0/5] Fix various races in UCSI

[Neil Armstrong <neil.armstrong@linaro.org>]

On 20/03/2024 11:53, Kenneth Crudup wrote:
> 
> Applied (cleanly) onto 6.8.1; I'll be testing over the next few days, but a few connects/disconnects mixed in with suspend/resume cycles shows no obvious issues (and everything seems to work).
> 
> Dell XPS 9320, BIOS 2.10.0
> 
> -K
> 
> On 3/20/24 00:39, Christian A. Ehrhardt wrote:
>> Fix various races in UCSI code:
>> - The EVENT_PENDING bit should be cleared under the PPM lock to
>>    avoid spurious re-checking of the connector status.
>> - The initial connector change notification during init may be
>>    lost which can cause a stuck UCSI controller. Observed by me
>>    and others during resume or after module reload.
>> - Unsupported commands must be ACKed. This was uncovered by the
>>    recent change from Jameson Thies that did sent unsupported commands.
>> - The DELL quirk still isn't quite complete and I've found a more
>>    elegant way to handle this. A connector change ack _is_ accepted
>>    on affected systems if it is bundled with a command ack.
>> - If we do two consecutive resets or the controller is already
>>    reset at boog the second reset might complete early because the
>>    reset complete bit is already set. ucsi_ccg.c has a work around
>>    for this but it looks like an more general issue to me.
>>
>> NOTE:
>> As a result of these individual fixes we could think about the
>> question if there are additional cases where we send some type
>> of command to the PPM while the bit that indicates its completion
>> is already set in CCI. And in fact there is one more case where
>> this can happen: The ack command that clears the connector change
>> is sent directly after the ack command for the previous command.
>> It might be possible to simply ack the connector change along with
>> the first command ucsi_handle_connector_change() and not at the
>> end. AFAICS the connector lock should protect us from races that
>> might arise out of this.
>>
>> Christian A. Ehrhardt (5):
>>    usb: typec: ucsi: Clear EVENT_PENDING under PPM lock
>>    usb: typec: ucsi: Check for notifications after init
>>    usb: typec: ucsi: Ack unsupported commands
>>    usb: typec: ucsi_acpi: Refactor and fix DELL quirk
>>    usb: typec: ucsi: Clear UCSI_CCI_RESET_COMPLETE before reset
>>
>>   drivers/usb/typec/ucsi/ucsi.c      | 56 ++++++++++++++++++++--
>>   drivers/usb/typec/ucsi/ucsi_acpi.c | 75 +++++++++++++-----------------
>>   2 files changed, 84 insertions(+), 47 deletions(-)
>>
> 

with [1] applied:

Tested-by: Neil Armstrong <neil.armstrong@linaro.org> # on SM8550-QRD
Tested-by: Neil Armstrong <neil.armstrong@linaro.org> # on SM8650-QRD
Tested-by: Neil Armstrong <neil.armstrong@linaro.org> # on SM8550-HDK

[1] https://lore.kernel.org/all/20240315171836.343830-1-jthies@google.com/

Thanks,
Neil