Linux wireless drivers development
 help / color / mirror / Atom feed
From: Zhu Yi <yi.zhu@intel.com>
To: linville@tuxdriver.com
Cc: linux-wireless@vger.kernel.org,
	Ron Rindjunsky <ron.rindjunsky@intel.com>,
	Tomas Winkler <tomas.winkler@intel.com>
Subject: [PATCH 22/43] iwlwifi: add iwl5000_tx_response structure
Date: Thu, 29 May 2008 16:35:07 +0800	[thread overview]
Message-ID: <1212050128-17132-23-git-send-email-yi.zhu@intel.com> (raw)
In-Reply-To: <1212050128-17132-22-git-send-email-yi.zhu@intel.com>

From: Ron Rindjunsky <ron.rindjunsky@intel.com>

This patch adds iwl5000_tx_repsons structure.

Signed-off-by: Ron Rindjunsky <ron.rindjunsky@intel.com>
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
---
 drivers/net/wireless/iwlwifi/iwl-commands.h |   48 ++++++++++++++++++++++++---
 1 files changed, 43 insertions(+), 5 deletions(-)

diff --git a/drivers/net/wireless/iwlwifi/iwl-commands.h b/drivers/net/wireless/iwlwifi/iwl-commands.h
index 6f62beb..bad0e94 100644
--- a/drivers/net/wireless/iwlwifi/iwl-commands.h
+++ b/drivers/net/wireless/iwlwifi/iwl-commands.h
@@ -1419,6 +1419,11 @@ enum {
  *     within the sending station (this 4965), rather than whether it was
  *     received successfully by the destination station.
  */
+struct agg_tx_status {
+	__le16 status;
+	__le16 sequence;
+} __attribute__ ((packed));
+
 struct iwl4965_tx_resp {
 	u8 frame_count;		/* 1 no aggregation, >1 aggregation */
 	u8 bt_kill_count;	/* # blocked by bluetooth (unused for agg) */
@@ -1453,11 +1458,6 @@ struct iwl4965_tx_resp {
 	__le32 status;	/* TX status (for aggregation status of 1st frame) */
 } __attribute__ ((packed));
 
-struct agg_tx_status {
-	__le16 status;
-	__le16 sequence;
-} __attribute__ ((packed));
-
 struct iwl4965_tx_resp_agg {
 	u8 frame_count;         /* 1 no aggregation, >1 aggregation */
 	u8 reserved1;
@@ -1472,6 +1472,44 @@ struct iwl4965_tx_resp_agg {
 					/* of 1st frame) */
 } __attribute__ ((packed));
 
+struct iwl5000_tx_resp {
+	u8 frame_count;		/* 1 no aggregation, >1 aggregation */
+	u8 bt_kill_count;	/* # blocked by bluetooth (unused for agg) */
+	u8 failure_rts;		/* # failures due to unsuccessful RTS */
+	u8 failure_frame;	/* # failures due to no ACK (unused for agg) */
+
+	/* For non-agg:  Rate at which frame was successful.
+	 * For agg:  Rate at which all frames were transmitted. */
+	__le32 rate_n_flags;	/* RATE_MCS_*  */
+
+	/* For non-agg:  RTS + CTS + frame tx attempts time + ACK.
+	 * For agg:  RTS + CTS + aggregation tx time + block-ack time. */
+	__le16 wireless_media_time;	/* uSecs */
+
+	__le16 reserved;
+	__le32 pa_power1;	/* RF power amplifier measurement (not used) */
+	__le32 pa_power2;
+
+	__le32 tfd_info;
+	__le16 seq_ctl;
+	__le16 byte_cnt;
+	__le32 tlc_info;
+	/*
+	 * For non-agg:  frame status TX_STATUS_*
+	 * For agg:  status of 1st frame, AGG_TX_STATE_*; other frame status
+	 *           fields follow this one, up to frame_count.
+	 *           Bit fields:
+	 *           11- 0:  AGG_TX_STATE_* status code
+	 *           15-12:  Retry count for 1st frame in aggregation (retries
+	 *                   occur if tx failed for this frame when it was a
+	 *                   member of a previous aggregation block).  If rate
+	 *                   scaling is used, retry count indicates the rate
+	 *                   table entry used for all frames in the new agg.
+	 *           31-16:  Sequence # for this frame's Tx cmd (not SSN!)
+	 */
+	struct agg_tx_status status;	/* TX status (in aggregation -
+					 * status of 1st frame) */
+} __attribute__ ((packed));
 /*
  * REPLY_COMPRESSED_BA = 0xc5 (response only, not a command)
  *
-- 
1.5.3.6


  reply	other threads:[~2008-05-29  8:37 UTC|newest]

Thread overview: 50+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2008-05-29  8:34 [PATCH 00/43] iwlwifi driver 05/29 updates Zhu Yi
2008-05-29  8:34 ` [PATCH 01/43] iwlwifi: move iwl_dump_nic_error_log to iwlcore module Zhu Yi
2008-05-29  8:34   ` [PATCH 02/43] iwlwifi: add RTC data address for iwl5000 Zhu Yi
2008-05-29  8:34     ` [PATCH 03/43] iwlwifi: use uCode error and event tables pointer w.r.t loaded image Zhu Yi
2008-05-29  8:34       ` [PATCH 04/43] iwlwifi: increase max payload of iwl_cmd Zhu Yi
2008-05-29  8:34         ` [PATCH 05/43] iwlwifi: create drivers debugfs dir under wiphy->debugfsdir Zhu Yi
2008-05-29  8:34           ` [PATCH 06/43] iwlwifi: mark 4965 ucode types Zhu Yi
2008-05-29  8:34             ` [PATCH 07/43] iwlwifi: remove unused variable form __iwl4965_down Zhu Yi
2008-05-29  8:34               ` [PATCH 08/43] iwlwifi: remove notif_missed_beacons variable Zhu Yi
2008-05-29  8:34                 ` [PATCH 09/43] iwlwifi: clean up alive_start routine Zhu Yi
2008-05-29  8:34                   ` [PATCH 10/43] iwlwifi: remove 4965 from alive_resp structures Zhu Yi
2008-05-29  8:34                     ` [PATCH 11/43] iwlwifi: setup correctly L1 L0S pi link values Zhu Yi
2008-05-29  8:34                       ` [PATCH 12/43] iwlwifi: implement apm reset flow Zhu Yi
2008-05-29  8:34                         ` [PATCH 13/43] iwlwifi: implement apm stop function Zhu Yi
2008-05-29  8:34                           ` [PATCH 14/43] iwlwifi: refactor stop master function Zhu Yi
2008-05-29  8:35                             ` [PATCH 15/43] iwlwifi: move txq_ctx_stop into iwl-tx.c Zhu Yi
2008-05-29  8:35                               ` [PATCH 16/43] iwlwifi: move iwl_rxq_stop into iwl-rx.c Zhu Yi
2008-05-29  8:35                                 ` [PATCH 17/43] iwlwifi: add remove station functionality Zhu Yi
2008-05-29  8:35                                   ` [PATCH 18/43] iwlwifi: move add sta handler to iwl-sta.c Zhu Yi
2008-05-29  8:35                                     ` [PATCH 19/43] iwlwifi: move iwl_rx_missed_beacon_notif to iwl-rx.c Zhu Yi
2008-05-29  8:35                                       ` [PATCH 20/43] iwlwifi-5000: implement initial calibration for 5000 Zhu Yi
2008-05-29  8:35                                         ` [PATCH 21/43] iwlwifi: activate status ready timeout only for run time ucode Zhu Yi
2008-05-29  8:35                                           ` Zhu Yi [this message]
2008-05-29  8:35                                             ` [PATCH 23/43] iwlwifi: move tx response common handlers to iwlcore Zhu Yi
2008-05-29  8:35                                               ` [PATCH 24/43] iwlwlifi: impelemnt 5000 tx response path Zhu Yi
2008-05-29  8:35                                                 ` [PATCH 25/43] iwlwifi: move 4965 tx response into iwl-4965.c Zhu Yi
2008-05-29  8:35                                                   ` [PATCH 26/43] iwlwifi: fix in-column rate scaling Zhu Yi
2008-05-29  8:35                                                     ` [PATCH 27/43] iwlwifi: move tx reclaim flow into iwl-tx Zhu Yi
2008-05-29  8:35                                                       ` [PATCH 28/43] iwlwifi: implement txq invalidate byte count table Zhu Yi
2008-05-29  8:35                                                         ` [PATCH 29/43] iwlwifi: iwl-5000 add rxon_assoc Zhu Yi
2008-05-29  8:35                                                           ` [PATCH 30/43] iwlwifi: move iwl_sta_modify_enable_tid_tx to iwl-sta.c Zhu Yi
2008-05-29  8:35                                                             ` [PATCH 31/43] iwlwifi: move aggregation code to iwl-tx.c Zhu Yi
2008-05-29  8:35                                                               ` [PATCH 32/43] iwlwifi: add frame count limit to link quality command Zhu Yi
2008-05-29  8:35                                                                 ` [PATCH 33/43] iwlwifi: Rx handlers common use for 4965 and 5000 Zhu Yi
2008-05-29  8:35                                                                   ` [PATCH 34/43] iwlwifi: move iwl_get_hw_mode to iwl-core.h Zhu Yi
2008-05-29  8:35                                                                     ` [PATCH 35/43] mac80211: fix ieee80211_get_buffered_bc Zhu Yi
2008-05-29  8:35                                                                       ` [PATCH 36/43] mac80211: fix deadlock in sta->lock Zhu Yi
2008-05-29  8:35                                                                         ` [PATCH 37/43] mac80211: sends HT IE to user level through wext Zhu Yi
2008-05-29  8:35                                                                           ` [PATCH 38/43] mac80211: allow disable FAT in specific configurations Zhu Yi
2008-05-29  8:35                                                                             ` [PATCH 39/43] iwlwifi: disable FAT channel when not permitted Zhu Yi
2008-05-29  8:35                                                                               ` [PATCH 40/43] iwlwifi: fix a memory leak in scan Zhu Yi
2008-05-29  8:35                                                                                 ` [PATCH 41/43] iwlwifi: remove debugfs entries before cfg80211 Zhu Yi
2008-05-29  8:35                                                                                   ` [PATCH 42/43] iwlwifi: send calibration results as HUGE commands Zhu Yi
2008-05-29  8:35                                                                                     ` [PATCH 43/43] iwlwifi: clean iwl4965_mac_config Zhu Yi
2008-05-30 11:47                                                                                 ` [PATCH 40/43] iwlwifi: fix a memory leak in scan Tomas Winkler
2008-05-29  9:37                                                                             ` [PATCH 38/43] mac80211: allow disable FAT in specific configurations Johannes Berg
2008-05-29  9:58                                                                               ` Tomas Winkler
2008-05-29 10:12                                                                                 ` Johannes Berg
2008-05-29 10:39                                                                                   ` Tomas Winkler
2008-05-29 10:49                                                                                     ` Johannes Berg

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1212050128-17132-23-git-send-email-yi.zhu@intel.com \
    --to=yi.zhu@intel.com \
    --cc=linux-wireless@vger.kernel.org \
    --cc=linville@tuxdriver.com \
    --cc=ron.rindjunsky@intel.com \
    --cc=tomas.winkler@intel.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox