Linux wireless drivers development
 help / color / mirror / Atom feed
From: Felix Fietkau <nbd@nbd.name>
To: linux-wireless@vger.kernel.org
Subject: [PATCH mt76-next 06/27] wifi: mt76: mt7996: find the last MLD link among the links torn down
Date: Tue,  6 Oct 2026 22:59:15 +0200	[thread overview]
Message-ID: <20261006205936.669125-6-nbd@nbd.name> (raw)
In-Reply-To: <20261006205936.669125-1-nbd@nbd.name>

On disassociation, mt7996_mac_sta_event() sends STA_REC_MLD_OFF when
the link it handles is the last of sta->valid_links, but it handles
only active links with driver state. On a station interface with one
active link out of two valid links, no link is ever the last one, so
the firmware never gets STA_REC_MLD_OFF for the MLD.

Walk the same set of links that mt7996_mcu_sta_mld_setup_tlv()
describes, and detect the last link within that set. The per-link
event handling moves into a helper that takes the set of links, so
that a later change can bring up links that became active after
association.

Fixes: c1d6dd5d03eb ("wifi: mt76: mt7996: Add mt7996_mcu_teardown_mld_sta rouine")
Signed-off-by: Felix Fietkau <nbd@nbd.name>
---
 .../net/wireless/mediatek/mt76/mt7996/main.c  | 47 ++++++++++---------
 1 file changed, 26 insertions(+), 21 deletions(-)

diff --git a/drivers/net/wireless/mediatek/mt76/mt7996/main.c b/drivers/net/wireless/mediatek/mt76/mt7996/main.c
index 0c229a8f071f..e5f74f23d469 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7996/main.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7996/main.c
@@ -1406,34 +1406,26 @@ mt7996_mac_sta_add(struct mt7996_dev *dev, struct ieee80211_vif *vif,
 }
 
 static int
-mt7996_mac_sta_event(struct mt7996_dev *dev, struct ieee80211_vif *vif,
-		     struct ieee80211_sta *sta, enum mt76_sta_event ev)
+mt7996_mac_sta_links_event(struct mt7996_dev *dev, struct ieee80211_vif *vif,
+			   struct ieee80211_sta *sta, unsigned long links,
+			   enum mt76_sta_event ev)
 {
 	struct mt7996_sta *msta = (struct mt7996_sta *)sta->drv_priv;
-	unsigned long links = sta->valid_links;
-	struct ieee80211_link_sta *link_sta;
+	unsigned long iter_links = links;
 	unsigned int link_id;
-	int err = 0;
+	int err;
 
-	mutex_lock(&dev->mt76.mutex);
-
-	for_each_sta_active_link(vif, sta, link_sta, link_id) {
+	for_each_set_bit(link_id, &iter_links, IEEE80211_MLD_MAX_NUM_LINKS) {
 		struct ieee80211_bss_conf *link_conf;
+		struct ieee80211_link_sta *link_sta;
 		struct mt7996_sta_link *msta_link;
 		struct mt7996_vif_link *link;
 		int i;
 
 		link_conf = link_conf_dereference_protected(vif, link_id);
-		if (!link_conf)
-			continue;
-
-		link = mt7996_vif_link(dev, vif, link_id);
-		if (!link)
-			continue;
-
+		link_sta = link_sta_dereference_protected(sta, link_id);
 		msta_link = mt7996_sta_link_protected(dev, msta, link_id);
-		if (!msta_link)
-			continue;
+		link = mt7996_vif_link(dev, vif, link_id);
 
 		switch (ev) {
 		case MT76_STA_EVENT_ASSOC:
@@ -1441,12 +1433,12 @@ mt7996_mac_sta_event(struct mt7996_dev *dev, struct ieee80211_vif *vif,
 						 link, msta_link,
 						 CONN_STATE_CONNECT, true);
 			if (err)
-				goto unlock;
+				return err;
 
 			err = mt7996_mcu_add_rate_ctrl(dev, msta_link->sta, vif,
 						       link_id, false);
 			if (err)
-				goto unlock;
+				return err;
 
 			msta_link->wcid.tx_info |= MT_WCID_TX_INFO_SET;
 			break;
@@ -1455,7 +1447,7 @@ mt7996_mac_sta_event(struct mt7996_dev *dev, struct ieee80211_vif *vif,
 						 link, msta_link,
 						 CONN_STATE_PORT_SECURE, false);
 			if (err)
-				goto unlock;
+				return err;
 			break;
 		case MT76_STA_EVENT_DISASSOC:
 			for (i = 0; i < ARRAY_SIZE(msta_link->twt.flow); i++)
@@ -1475,7 +1467,20 @@ mt7996_mac_sta_event(struct mt7996_dev *dev, struct ieee80211_vif *vif,
 			break;
 		}
 	}
-unlock:
+
+	return 0;
+}
+
+static int
+mt7996_mac_sta_event(struct mt7996_dev *dev, struct ieee80211_vif *vif,
+		     struct ieee80211_sta *sta, enum mt76_sta_event ev)
+{
+	int err;
+
+	mutex_lock(&dev->mt76.mutex);
+	err = mt7996_mac_sta_links_event(dev, vif, sta,
+					 mt7996_mac_sta_links(dev, vif, sta),
+					 ev);
 	mutex_unlock(&dev->mt76.mutex);
 
 	return err;
-- 
2.47.3


  parent reply	other threads:[~2026-10-06 20:59 UTC|newest]

Thread overview: 27+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2026-10-06 20:59 [PATCH mt76-next 01/27] wifi: mt76: abort a scan only for a link change on the scanning radio Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 02/27] wifi: mt76: mt7996: enable the SKU power limit table Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 03/27] wifi: mt76: mt7996: set sniffer mode on a radio that is already running Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 04/27] wifi: mt76: mt7996: update the address of an AP link that is added again Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 05/27] wifi: mt76: mt7996: size the MLD setup TLV by the links it describes Felix Fietkau
2026-10-06 20:59 ` Felix Fietkau [this message]
2026-10-06 20:59 ` [PATCH mt76-next 07/27] wifi: mt76: mt7996: upload only the keys of the link being set up Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 08/27] wifi: mt76: mt7996: do not walk the vif keys when a link is destroyed Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 09/27] wifi: mt76: mt7996: report station statistics from the primary link Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 10/27] wifi: mt76: mt7996: clear all link wcid entries in sta_pre_rcu_remove Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 11/27] wifi: mt76: mt7996: free the WTBL index if a link allocation fails Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 12/27] wifi: mt76: mt7996: pick the secondary link from links with driver state Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 13/27] wifi: mt76: mt7996: make a returning link primary if a station has none Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 14/27] wifi: mt76: mt7996: do not reuse the deflink of a removed station link Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 15/27] wifi: mt76: mt7996: keep a returning link when adding station links fails Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 16/27] wifi: mt76: mt7996: add the station BMC entry as new once per BSSID Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 17/27] wifi: mt76: mt7996: keep 4-address and decap state per station Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 18/27] wifi: mt76: mt7996: do not add a station link in disconnected state Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 19/27] wifi: mt76: mt7996: record the connection state of a station Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 20/27] wifi: mt76: mt7996: keep the block ack session parameters per station Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 21/27] wifi: mt76: mt7996: set up the BSS of a late station link before its peer Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 22/27] wifi: mt76: mt7996: bring up station links added after association Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 23/27] wifi: mt76: mt7996: set up block ack sessions on station links added later Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 24/27] wifi: mt76: mt7996: restore a station link that returns after a removal Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 25/27] wifi: mt76: mt7996: fix PLE free page and AC queue register offsets Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 26/27] wifi: mt76: mt7996: fix the hw-queues debugfs queue requests Felix Fietkau
2026-10-06 20:59 ` [PATCH mt76-next 27/27] wifi: mt76: mt7996: disable the RX NAPIs before the DMA cleanup Felix Fietkau

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20261006205936.669125-6-nbd@nbd.name \
    --to=nbd@nbd.name \
    --cc=linux-wireless@vger.kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox