[PATCH wireless] wifi: b43: write the HT-PHY TX power estimates as 16-bit entries

[PATCH wireless] wifi: b43: write the HT-PHY TX power estimates as 16-bit entries

[Rosen Penev]

b43_phy_ht_tx_power_ctl_setup() computes the 64 power estimates per
core in a u32 array and writes them with b43_httab_write_bulk() as
16-bit entries, which reads the array as u16. Each table then holds
the low half of an estimate in every even entry and its high half, 0,
in every odd one, and only the first 32 estimates are written. The
hardware TX power control maps half of the TSSI readings to a power
of 0 and raises the TX gain towards its maximum.

The wl driver writes the same 64 entries of tables 26-28 as 16-bit
values, which match the ones b43 computes. Use a u16 array.

Fixes: 5949e0406041 ("b43: HT-PHY: setup TX power control")
Signed-off-by: Rosen Penev <rosenp@gmail.com>
---
 drivers/net/wireless/broadcom/b43/phy_ht.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/wireless/broadcom/b43/phy_ht.c b/drivers/net/wireless/broadcom/b43/phy_ht.c
index fab8399c64f7..b63e7734db6f 100644
--- a/drivers/net/wireless/broadcom/b43/phy_ht.c
+++ b/drivers/net/wireless/broadcom/b43/phy_ht.c
@@ -714,7 +714,7 @@ static void b43_phy_ht_tx_power_ctl_setup(struct b43_wldev *dev)
 
 	for (c = 0; c < 3; c++) {
 		s32 num, den, pwr;
-		u32 regval[64];
+		u16 regval[64];
 
 		for (i = 0; i < 64; i++) {
 			num = 8 * (16 * b0[c] + b1[c] * i);
-- 
2.56.0