* [PATCH] ath10k: add error handling to ath10k_pci_wait()
@ 2013-10-17 8:36 Kalle Valo
2013-10-17 14:24 ` Michal Kazior
2013-10-21 14:19 ` Kalle Valo
0 siblings, 2 replies; 4+ messages in thread
From: Kalle Valo @ 2013-10-17 8:36 UTC (permalink / raw)
To: ath10k; +Cc: linux-wireless
ath10k_pci_wait() didn't notify any errors to callers, it
just printed a warning so add proper error handling.
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
---
drivers/net/wireless/ath/ath10k/pci.c | 28 ++++++++++++++++++++++++----
1 file changed, 24 insertions(+), 4 deletions(-)
diff --git a/drivers/net/wireless/ath/ath10k/pci.c b/drivers/net/wireless/ath/ath10k/pci.c
index 1e9cfcc9..92759cd 100644
--- a/drivers/net/wireless/ath/ath10k/pci.c
+++ b/drivers/net/wireless/ath/ath10k/pci.c
@@ -525,15 +525,19 @@ static bool ath10k_pci_target_is_awake(struct ath10k *ar)
return (RTC_STATE_V_GET(val) == RTC_STATE_V_ON);
}
-static void ath10k_pci_wait(struct ath10k *ar)
+static int ath10k_pci_wait(struct ath10k *ar)
{
int n = 100;
while (n-- && !ath10k_pci_target_is_awake(ar))
msleep(10);
- if (n < 0)
+ if (n < 0) {
ath10k_warn("Unable to wakeup target\n");
+ return -ETIMEDOUT;
+ }
+
+ return 0;
}
int ath10k_do_pci_wake(struct ath10k *ar)
@@ -2227,7 +2231,13 @@ static int ath10k_pci_start_intr_legacy(struct ath10k *ar)
ar_pci->mem + PCIE_LOCAL_BASE_ADDRESS +
PCIE_SOC_WAKE_ADDRESS);
- ath10k_pci_wait(ar);
+ ret = ath10k_pci_wait(ar);
+ if (ret) {
+ ath10k_warn("Failed to enable legacy interrupt, target did not wake up: %d\n",
+ ret);
+ free_irq(ar_pci->pdev->irq, ar);
+ return ret;
+ }
/*
* A potential race occurs here: The CORE_BASE write
@@ -2290,6 +2300,10 @@ static int ath10k_pci_start_intr(struct ath10k *ar)
}
ret = ath10k_pci_start_intr_legacy(ar);
+ if (ret) {
+ ath10k_warn("Failed to start legacy interrupts: %d\n", ret);
+ return ret;
+ }
exit:
ar_pci->num_msi_intrs = num;
@@ -2315,13 +2329,19 @@ static int ath10k_pci_reset_target(struct ath10k *ar)
{
struct ath10k_pci *ar_pci = ath10k_pci_priv(ar);
int wait_limit = 300; /* 3 sec */
+ int ret;
/* Wait for Target to finish initialization before we proceed. */
iowrite32(PCIE_SOC_WAKE_V_MASK,
ar_pci->mem + PCIE_LOCAL_BASE_ADDRESS +
PCIE_SOC_WAKE_ADDRESS);
- ath10k_pci_wait(ar);
+ ret = ath10k_pci_wait(ar);
+ if (ret) {
+ ath10k_warn("Failed to reset target, target did not wake up: %d\n",
+ ret);
+ return ret;
+ }
while (wait_limit-- &&
!(ioread32(ar_pci->mem + FW_INDICATOR_ADDRESS) &
^ permalink raw reply related [flat|nested] 4+ messages in thread* Re: [PATCH] ath10k: add error handling to ath10k_pci_wait()
2013-10-17 8:36 [PATCH] ath10k: add error handling to ath10k_pci_wait() Kalle Valo
@ 2013-10-17 14:24 ` Michal Kazior
2013-10-17 14:27 ` Kalle Valo
2013-10-21 14:19 ` Kalle Valo
1 sibling, 1 reply; 4+ messages in thread
From: Michal Kazior @ 2013-10-17 14:24 UTC (permalink / raw)
To: Kalle Valo; +Cc: ath10k, linux-wireless
On 17 October 2013 01:36, Kalle Valo <kvalo@qca.qualcomm.com> wrote:
> ath10k_pci_wait() didn't notify any errors to callers, it
> just printed a warning so add proper error handling.
>
> Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
> ---
> drivers/net/wireless/ath/ath10k/pci.c | 28 ++++++++++++++++++++++++----
> 1 file changed, 24 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/net/wireless/ath/ath10k/pci.c b/drivers/net/wireless/ath/ath10k/pci.c
> index 1e9cfcc9..92759cd 100644
> --- a/drivers/net/wireless/ath/ath10k/pci.c
> +++ b/drivers/net/wireless/ath/ath10k/pci.c
> @@ -525,15 +525,19 @@ static bool ath10k_pci_target_is_awake(struct ath10k *ar)
> return (RTC_STATE_V_GET(val) == RTC_STATE_V_ON);
> }
>
> -static void ath10k_pci_wait(struct ath10k *ar)
> +static int ath10k_pci_wait(struct ath10k *ar)
> {
> int n = 100;
>
> while (n-- && !ath10k_pci_target_is_awake(ar))
> msleep(10);
>
> - if (n < 0)
> + if (n < 0) {
> ath10k_warn("Unable to wakeup target\n");
> + return -ETIMEDOUT;
> + }
> +
> + return 0;
> }
>
> int ath10k_do_pci_wake(struct ath10k *ar)
> @@ -2227,7 +2231,13 @@ static int ath10k_pci_start_intr_legacy(struct ath10k *ar)
> ar_pci->mem + PCIE_LOCAL_BASE_ADDRESS +
> PCIE_SOC_WAKE_ADDRESS);
>
> - ath10k_pci_wait(ar);
> + ret = ath10k_pci_wait(ar);
> + if (ret) {
> + ath10k_warn("Failed to enable legacy interrupt, target did not wake up: %d\n",
> + ret);
> + free_irq(ar_pci->pdev->irq, ar);
> + return ret;
> + }
I think we could actually use ath10k_do_pci_wake/sleep() here (see
above iowrite). It does basically the same thing - sets the wake
register and waits until HW wakes up. I think ath10k_pci_wait() could
even go away.
>
> /*
> * A potential race occurs here: The CORE_BASE write
> @@ -2290,6 +2300,10 @@ static int ath10k_pci_start_intr(struct ath10k *ar)
> }
>
> ret = ath10k_pci_start_intr_legacy(ar);
> + if (ret) {
> + ath10k_warn("Failed to start legacy interrupts: %d\n", ret);
> + return ret;
> + }
>
> exit:
> ar_pci->num_msi_intrs = num;
> @@ -2315,13 +2329,19 @@ static int ath10k_pci_reset_target(struct ath10k *ar)
> {
> struct ath10k_pci *ar_pci = ath10k_pci_priv(ar);
> int wait_limit = 300; /* 3 sec */
> + int ret;
>
> /* Wait for Target to finish initialization before we proceed. */
> iowrite32(PCIE_SOC_WAKE_V_MASK,
> ar_pci->mem + PCIE_LOCAL_BASE_ADDRESS +
> PCIE_SOC_WAKE_ADDRESS);
>
> - ath10k_pci_wait(ar);
> + ret = ath10k_pci_wait(ar);
> + if (ret) {
> + ath10k_warn("Failed to reset target, target did not wake up: %d\n",
> + ret);
> + return ret;
> + }
Ditto.
Michał
^ permalink raw reply [flat|nested] 4+ messages in thread* Re: [PATCH] ath10k: add error handling to ath10k_pci_wait()
2013-10-17 14:24 ` Michal Kazior
@ 2013-10-17 14:27 ` Kalle Valo
0 siblings, 0 replies; 4+ messages in thread
From: Kalle Valo @ 2013-10-17 14:27 UTC (permalink / raw)
To: Michal Kazior; +Cc: ath10k, linux-wireless
Michal Kazior <michal.kazior@tieto.com> writes:
> On 17 October 2013 01:36, Kalle Valo <kvalo@qca.qualcomm.com> wrote:
>> ath10k_pci_wait() didn't notify any errors to callers, it
>> just printed a warning so add proper error handling.
>>
>> Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
[...]
>> @@ -2227,7 +2231,13 @@ static int ath10k_pci_start_intr_legacy(struct ath10k *ar)
>> ar_pci->mem + PCIE_LOCAL_BASE_ADDRESS +
>> PCIE_SOC_WAKE_ADDRESS);
>>
>> - ath10k_pci_wait(ar);
>> + ret = ath10k_pci_wait(ar);
>> + if (ret) {
>> + ath10k_warn("Failed to enable legacy interrupt, target did not wake up: %d\n",
>> + ret);
>> + free_irq(ar_pci->pdev->irq, ar);
>> + return ret;
>> + }
>
> I think we could actually use ath10k_do_pci_wake/sleep() here (see
> above iowrite). It does basically the same thing - sets the wake
> register and waits until HW wakes up. I think ath10k_pci_wait() could
> even go away.
That would be nice, I'll take a look. Thanks for the review.
--
Kalle Valo
^ permalink raw reply [flat|nested] 4+ messages in thread
* Re: [PATCH] ath10k: add error handling to ath10k_pci_wait()
2013-10-17 8:36 [PATCH] ath10k: add error handling to ath10k_pci_wait() Kalle Valo
2013-10-17 14:24 ` Michal Kazior
@ 2013-10-21 14:19 ` Kalle Valo
1 sibling, 0 replies; 4+ messages in thread
From: Kalle Valo @ 2013-10-21 14:19 UTC (permalink / raw)
To: ath10k; +Cc: linux-wireless
Kalle Valo <kvalo@qca.qualcomm.com> writes:
> ath10k_pci_wait() didn't notify any errors to callers, it
> just printed a warning so add proper error handling.
>
> Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
Applied, I just changed the commit log to this:
commit f3782744c9b50edf94d28e37a937ff84f267dfab
Author: Kalle Valo <kvalo@qca.qualcomm.com>
Date: Thu Oct 17 11:36:15 2013 +0300
ath10k: add error handling to ath10k_pci_wait()
ath10k_pci_wait() didn't notify any errors to callers, it
just printed a warning so add proper error handling. This fixes
a crash Ben reported:
ath10k: MSI-X interrupt handling (8 intrs)
ath10k: Unable to wakeup target
ath10k: target took longer 5000 us to wake up (awake count 1)
ath10k: Failed to get pcie state addr: -16
ath10k: early firmware event indicated
BUG: unable to handle kernel NULL pointer dereference at 0000000000000004
IP: [<ffffffffa06ae46c>] ath10k_ce_completed_send_next+0x47/0x122 [ath10k_pci]
Reported-by: Ben Greear <greearb@candelatech.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
--
Kalle Valo
^ permalink raw reply [flat|nested] 4+ messages in thread
end of thread, other threads:[~2013-10-21 14:19 UTC | newest]
Thread overview: 4+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2013-10-17 8:36 [PATCH] ath10k: add error handling to ath10k_pci_wait() Kalle Valo
2013-10-17 14:24 ` Michal Kazior
2013-10-17 14:27 ` Kalle Valo
2013-10-21 14:19 ` Kalle Valo
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox