Re: [PATCH] wifi: rtw88: enable TX reports for the management queue

[Andrey Skvortsov <andrej.skvortzov@gmail.com>]

On 25-06-30 01:51, Ping-Ke Shih wrote:
> Andrey Skvortsov <andrej.skvortzov@gmail.com> wrote:
> > This is needed for AP mode. Otherwise client sees the network, but
> > can't connect to it.
> > 
> > REG_FWHW_TXQ_CTRL+1 is set to WLAN_TXQ_RPT_EN (0x1F) in common mac
> > init function (__rtw8723x_mac_init), but the value was overwritten
> > from mac table later.
> 
> Since the tables were copied from vendor driver, I suspect people might
> overwrite the tables again resulting in regression. 
> 
> So we can add a mac_post_init to set the value after loading parameters:
> 
>   rtw_mac_init(rtwdev); // not set REG_FWHW_TXQ_CTRL+1 to WLAN_TXQ_RPT_EN
> 
>   chip->ops->phy_set_param(rtwdev); // "0x421, 0x0000000F," by table
> 
>   rtw_mac_postinit(rtwdev); // set REG_FWHW_TXQ_CTRL+1 to WLAN_TXQ_RPT_EN 
> 
> Only rtw8703b/rtw8723d implement postinit ops.
> 

Thanks for the feedback, I'll add this in v2.

-- 
Best regards,
Andrey Skvortsov