Re: [RFC v2 0/7] cfg80211/mac80211: support defining multiple radios per wiphy

[Aditya Kumar Singh <quic_adisi@quicinc.com>]

On 6/6/24 00:01, Felix Fietkau wrote:
> The prerequisite for MLO support in cfg80211/mac80211 is that all the links
> participating in MLO must be from the same wiphy/ieee80211_hw. To meet this
> expectation, some drivers may need to group multiple discrete hardware each
> acting as a link in MLO under single wiphy.
> 
> With this series, the bands and supported frequencies of each individual
> radio are reported to user space. This allows user space to figure out the
> limitations of what combination of channels can be used concurrently.
> 
> Each mac80211 channel context is assigned to a radio based on radio specific
> frequency ranges and interface combinations.
> 
> This is loosely based on Karthikeyan Periyasamy's series
> "[PATCH 00/13] wifi: Add multi physical hardware iface combination support"
> with some differences:
> 
>   - a struct wiphy_radio is defined, which holds the frequency ranges and
>     a full struct ieee80211_iface_combination array
>   - a channel context is explicitly assigned to a radio when created
>   - both global and per-radio interface combination limits are checked
>     and enforced on channel context assignment
> 
> Changes since RFC:
>   - replace static per-radio number of channels limit with full ifcomb
>     checks
>   - remove band bitmask in favor of only using freq ranges

What about handling 2 GHz + 5 GHz issue we discussed in v1 related to 
radar detection width and num chan ctx? Is that taken care?