[PATCH v4 0/2] powerpc: Board support for GE Fanuc SBC610

[Martyn Welch <martyn.welch@gefanuc.com>]

The following series implements basic board support for GE Fanuc's SBC610, a 
6U single board computer, based on Freescale's MPC8641D.

This series provides basic functionality:
- The board can boot with a serial console.
- Ethernet works, though the phys are polled.
- The PCI bus is scanned and sata functions.

Signed-off-by: Martyn Welch <martyn.welch@gefanuc.com>
---

Kumar: Thanks once again for your comments.

I have altered "reg" variables, inline with suggestions and existing dts files.

I have not removed the cpu *-frequency entires - these are required to be
present for u-boot 1.2.0, which will alter but not create them.

Martyn

 arch/powerpc/boot/dts/gef_sbc610.dts     |  259 ++++++++++++++++++++++++++++++
 arch/powerpc/platforms/86xx/Kconfig      |    9 +
 arch/powerpc/platforms/86xx/Makefile     |    1 
 arch/powerpc/platforms/86xx/gef_sbc610.c |  152 ++++++++++++++++++
 4 files changed, 420 insertions(+), 1 deletions(-)