[PATCH] 2.5.7-dj1 add 5 help texts to arch/cris/Config.help

[PATCH] 2.5.7-dj1 add 5 help texts to arch/cris/Config.help

[Steven Cole]

This patch adds 5 help texts to arch/cris/Config.help.
The texts were obtained from ESR's v2.97 Configure.help.

Steven

--- linux-2.5.7-dj1/arch/cris/Config.help.orig	Mon Mar 25 13:53:25 2002
+++ linux-2.5.7-dj1/arch/cris/Config.help	Mon Mar 25 13:53:59 2002
@@ -392,3 +392,26 @@
 CONFIG_ETRAX_RESCUE_SER3
   Use serial port 3 as the rescue port.
 
+CONFIG_ETRAX_POWERBUTTON_BIT
+  Configure where power button is connected.
+
+CONFIG_ETRAX_ROOT_DEVICE
+  Specifies the device that should be mounted as root file system
+  when booting from flash. The axisflashmap driver adds an additional
+  mtd partition for the appended root file system image, so this option
+  should normally be the mtdblock device for the partition after the
+  last partition in the partition table.
+
+CONFIG_ETRAX_SHUTDOWN_BIT
+  Configure what pin on CSPO-port that is used for controlling power
+  supply.
+
+CONFIG_ETRAX_SOFT_SHUTDOWN
+  Enable this if Etrax is used with a power-supply that can be turned
+  off and on with PS_ON signal. Gives the possibility to detect
+  powerbutton and then do a power off after unmounting disks.
+
+CONFIG_ETRAX_WATCHDOG_NICE_DOGGY
+  By enabling this you make sure that the watchdog does not bite while
+  printing oopses. Recommended for development systems but not for
+  production releases.