public inbox for linux-kernel@vger.kernel.org
 help / color / mirror / Atom feed
From: Chaotian Jing <chaotian.jing@mediatek.com>
To: NeilBrown <neil@brown.name>
Cc: Ulf Hansson <ulf.hansson@linaro.org>, <linux-mmc@vger.kernel.org>,
	<linux-kernel@vger.kernel.org>, <thirtythreeforty@gmail.com>
Subject: Re: [PATCH 3/4] mmc: mtk-sd: enable internal card-detect logic.
Date: Sun, 5 May 2019 15:52:19 +0800	[thread overview]
Message-ID: <1557042739.18628.35.camel@mhfsdcap03> (raw)
In-Reply-To: <155696549691.8632.10285608726034686897.stgit@noble.brown>

On Sat, 2019-05-04 at 20:24 +1000, NeilBrown wrote:
> The mtk-sd silicon has integrated card-detect logic that is
> enabled on the MT7621.  The circuit is phased out on newer hardware so
> we should be careful to only enabled it on hardware known to support
> it.  This a new "use_internal_cd" flag in struct mtk_mmc_compatible.
> 
> If the sdhci isn't marked non-removable and doesn't have a
> cd-gpio configured, and if use_internal_cd is set, then assume the
> internal cd logic should be used as recommended by
>  Documentation/devicetree/bindings/mmc/mmc.txt
> 
> Signed-off-by: NeilBrown <neil@brown.name>
 Reviewed-by:Chaotian Jing <chaotian.jing@mediatek.com>
> ---
>  drivers/mmc/host/mtk-sd.c |   64 ++++++++++++++++++++++++++++++++++++++++++---
>  1 file changed, 60 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/mmc/host/mtk-sd.c b/drivers/mmc/host/mtk-sd.c
> index 0c2be4f54b1f..c518cc208a1f 100644
> --- a/drivers/mmc/host/mtk-sd.c
> +++ b/drivers/mmc/host/mtk-sd.c
> @@ -300,6 +300,8 @@
>  #define CMD_TIMEOUT         (HZ/10 * 5)	/* 100ms x5 */
>  #define DAT_TIMEOUT         (HZ    * 5)	/* 1000ms x5 */
>  
> +#define DEFAULT_DEBOUNCE	(8)	/* 8 cycles CD debounce */
> +
>  #define PAD_DELAY_MAX	32 /* PAD delay cells */
>  /*--------------------------------------------------------------------------*/
>  /* Descriptor Structure                                                     */
> @@ -372,6 +374,7 @@ struct mtk_mmc_compatible {
>  	bool stop_clk_fix;
>  	bool enhance_rx;
>  	bool support_64g;
> +	bool use_internal_cd;
>  };
>  
>  struct msdc_tune_para {
> @@ -430,6 +433,7 @@ struct msdc_host {
>  	bool hs400_cmd_resp_sel_rising;
>  				 /* cmd response sample selection for HS400 */
>  	bool hs400_mode;	/* current eMMC will run at hs400 mode */
> +	bool internal_cd;	/* Use internal card-detect logic */
>  	struct msdc_save_para save_para; /* used when gate HCLK */
>  	struct msdc_tune_para def_tune_para; /* default tune setting */
>  	struct msdc_tune_para saved_tune_para; /* tune result of CMD21/CMD19 */
> @@ -526,6 +530,7 @@ static const struct mtk_mmc_compatible mt7620_compat = {
>  	.busy_check = false,
>  	.stop_clk_fix = false,
>  	.enhance_rx = false,
> +	.use_internal_cd = true,
>  };
>  
>  static const struct of_device_id msdc_of_ids[] = {
> @@ -1430,6 +1435,12 @@ static irqreturn_t msdc_irq(int irq, void *dev_id)
>  			sdio_signal_irq(host->mmc);
>  		}
>  
> +		if ((events & event_mask) & MSDC_INT_CDSC) {
> +			if (host->internal_cd)
> +				mmc_detect_change(host->mmc, msecs_to_jiffies(20));
> +			events &= ~MSDC_INT_CDSC;
> +		}
> +
>  		if (!(events & (event_mask & ~MSDC_INT_SDIOIRQ)))
>  			break;
>  
> @@ -1463,14 +1474,24 @@ static void msdc_init_hw(struct msdc_host *host)
>  	/* Reset */
>  	msdc_reset_hw(host);
>  
> -	/* Disable card detection */
> -	sdr_clr_bits(host->base + MSDC_PS, MSDC_PS_CDEN);
> -
>  	/* Disable and clear all interrupts */
>  	writel(0, host->base + MSDC_INTEN);
>  	val = readl(host->base + MSDC_INT);
>  	writel(val, host->base + MSDC_INT);
>  
> +	/* Configure card detection */
> +	if (host->internal_cd) {
> +		sdr_set_field(host->base + MSDC_PS, MSDC_PS_CDDEBOUNCE,
> +			      DEFAULT_DEBOUNCE);
> +		sdr_set_bits(host->base + MSDC_PS, MSDC_PS_CDEN);
> +		sdr_set_bits(host->base + MSDC_INTEN, MSDC_INTEN_CDSC);
> +		sdr_set_bits(host->base + SDC_CFG, SDC_CFG_INSWKUP);
> +	} else {
> +		sdr_clr_bits(host->base + SDC_CFG, SDC_CFG_INSWKUP);
> +		sdr_clr_bits(host->base + MSDC_PS, MSDC_PS_CDEN);
> +		sdr_clr_bits(host->base + MSDC_INTEN, MSDC_INTEN_CDSC);
> +	}
> +
>  	if (host->top_base) {
>  		writel(0, host->top_base + EMMC_TOP_CONTROL);
>  		writel(0, host->top_base + EMMC_TOP_CMD);
> @@ -1580,6 +1601,13 @@ static void msdc_init_hw(struct msdc_host *host)
>  static void msdc_deinit_hw(struct msdc_host *host)
>  {
>  	u32 val;
> +
> +	if (host->internal_cd) {
> +		/* Disabled card-detect */
> +		sdr_clr_bits(host->base + MSDC_PS, MSDC_PS_CDEN);
> +		sdr_clr_bits(host->base + SDC_CFG, SDC_CFG_INSWKUP);
> +	}
> +
>  	/* Disable and clear all interrupts */
>  	writel(0, host->base + MSDC_INTEN);
>  
> @@ -2078,13 +2106,31 @@ static void msdc_ack_sdio_irq(struct mmc_host *mmc)
>  	__msdc_enable_sdio_irq(mmc, 1);
>  }
>  
> +static int msdc_get_cd(struct mmc_host *mmc)
> +{
> +	struct msdc_host *host = mmc_priv(mmc);
> +	int val;
> +
> +	if (mmc->caps & MMC_CAP_NONREMOVABLE)
> +		return 1;
> +
> +	if (!host->internal_cd)
> +		return mmc_gpio_get_cd(mmc);
> +
> +	val = readl(host->base + MSDC_PS) & MSDC_PS_CDSTS;
> +	if (mmc->caps2 & MMC_CAP2_CD_ACTIVE_HIGH)
> +		return !!val;
> +	else
> +		return !val;
> +}
> +
>  static const struct mmc_host_ops mt_msdc_ops = {
>  	.post_req = msdc_post_req,
>  	.pre_req = msdc_pre_req,
>  	.request = msdc_ops_request,
>  	.set_ios = msdc_ops_set_ios,
>  	.get_ro = mmc_gpio_get_ro,
> -	.get_cd = mmc_gpio_get_cd,
> +	.get_cd = msdc_get_cd,
>  	.enable_sdio_irq = msdc_enable_sdio_irq,
>  	.ack_sdio_irq = msdc_ack_sdio_irq,
>  	.start_signal_voltage_switch = msdc_ops_switch_volt,
> @@ -2216,6 +2262,16 @@ static int msdc_drv_probe(struct platform_device *pdev)
>  	else
>  		mmc->f_min = DIV_ROUND_UP(host->src_clk_freq, 4 * 4095);
>  
> +	if (!(mmc->caps & MMC_CAP_NONREMOVABLE) &&
> +	    !mmc_can_gpio_cd(mmc) &&
> +	    host->dev_comp->use_internal_cd) {
> +		/*
> +		 * Is removable but no GPIO declared, so
> +		 * use internal functionality.
> +		 */
> +		host->internal_cd = true;
> +	}
> +
>  	if (mmc->caps & MMC_CAP_SDIO_IRQ)
>  		mmc->caps2 |= MMC_CAP2_SDIO_IRQ_NOTHREAD;
>  
> 
> 



  reply	other threads:[~2019-05-05  7:52 UTC|newest]

Thread overview: 10+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2019-05-04 10:24 [PATCH 0/4] mtk-sd enhancement to support MT7621 - V2 NeilBrown
2019-05-04 10:24 ` [PATCH 1/4] mmc: mtk-sd: don't hard-code interrupt trigger type NeilBrown
2019-05-05  7:43   ` Chaotian Jing
2019-05-04 10:24 ` [PATCH 2/4] mmc: mtk-sd: add support for config found in mt7620 family SOCs NeilBrown
2019-05-05  7:49   ` Chaotian Jing
2019-05-04 10:24 ` [PATCH 3/4] mmc: mtk-sd: enable internal card-detect logic NeilBrown
2019-05-05  7:52   ` Chaotian Jing [this message]
2019-05-04 10:24 ` [PATCH 4/4] mmc: mtk-sd: select REGULATOR NeilBrown
2019-05-05  7:52   ` Chaotian Jing
2019-05-06  9:51 ` [PATCH 0/4] mtk-sd enhancement to support MT7621 - V2 Ulf Hansson

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1557042739.18628.35.camel@mhfsdcap03 \
    --to=chaotian.jing@mediatek.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mmc@vger.kernel.org \
    --cc=neil@brown.name \
    --cc=thirtythreeforty@gmail.com \
    --cc=ulf.hansson@linaro.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox