[PATCH net-next 13/24] net: dsa: mt7530: move XTAL check to mt7530_setup()

[arinc9.unal@gmail.com]

From: Arınç ÜNAL <arinc.unal@arinc9.com>

The crystal frequency concerns the switch core. The frequency should be
checked when the switch is being set up so the driver can reject the
unsupported hardware earlier and without requiring port 6 to be used.

Move it to mt7530_setup().

Tested-by: Arınç ÜNAL <arinc.unal@arinc9.com>
Signed-off-by: Arınç ÜNAL <arinc.unal@arinc9.com>
---
 drivers/net/dsa/mt7530.c | 18 ++++++++++--------
 1 file changed, 10 insertions(+), 8 deletions(-)

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index 2addd5e7fbe6..04a48829465c 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -408,13 +408,6 @@ mt7530_setup_port6(struct dsa_switch *ds, phy_interface_t interface)
 
 	xtal = mt7530_read(priv, MT7530_HWTRAP) & HWTRAP_XTAL_MASK;
 
-	if (xtal == HWTRAP_XTAL_20MHZ) {
-		dev_err(priv->dev,
-			"%s: MT7530 with a 20MHz XTAL is not supported!\n",
-			__func__);
-		return -EINVAL;
-	}
-
 	switch (interface) {
 	case PHY_INTERFACE_MODE_RGMII:
 		trgint = 0;
@@ -2136,7 +2129,7 @@ mt7530_setup(struct dsa_switch *ds)
 	struct mt7530_dummy_poll p;
 	phy_interface_t interface;
 	struct dsa_port *cpu_dp;
-	u32 id, val;
+	u32 id, val, xtal;
 	int ret, i;
 
 	/* The parent node of master netdev which holds the common system
@@ -2206,6 +2199,15 @@ mt7530_setup(struct dsa_switch *ds)
 		return -ENODEV;
 	}
 
+	xtal = mt7530_read(priv, MT7530_HWTRAP) & HWTRAP_XTAL_MASK;
+
+	if (xtal == HWTRAP_XTAL_20MHZ) {
+		dev_err(priv->dev,
+			"%s: MT7530 with a 20MHz XTAL is not supported!\n",
+			__func__);
+		return -EINVAL;
+	}
+
 	/* Reset the switch through internal reset */
 	mt7530_write(priv, MT7530_SYS_CTRL,
 		     SYS_CTRL_PHY_RST | SYS_CTRL_SW_RST |
-- 
2.37.2