[PATCH] usb: dwc3: gadget: Fix controller timeout at dwc3_gadget_suspend()

[Roger Quadros <rogerq@kernel.org>]

If gadget driver is loaded and we are connected to a USB host,
all transfers must be stopped before stopping the controller else
we will not get a clean stop i.e. dwc3_gadget_run_stop() will take
several seconds to complete and will return -ETIMEDOUT. Fix this.

No need to stop the controller at dwc3_gadget_suspend() if
dwc->softconnect is 0 as controller is already stopped.

Handle error cases properly in dwc3_gadget_suspend().

Suggested-by: Thinh Nguyen <Thinh.Nguyen@synopsys.com>
Signed-off-by: Roger Quadros <rogerq@kernel.org>
---
 drivers/usb/dwc3/gadget.c | 69 ++++++++++++++++++++-------------------
 1 file changed, 35 insertions(+), 34 deletions(-)

diff --git a/drivers/usb/dwc3/gadget.c b/drivers/usb/dwc3/gadget.c
index 287ea6ee2463..b63502afb144 100644
--- a/drivers/usb/dwc3/gadget.c
+++ b/drivers/usb/dwc3/gadget.c
@@ -2668,6 +2668,21 @@ static int dwc3_gadget_soft_disconnect(struct dwc3 *dwc)
 	return dwc3_gadget_run_stop(dwc, false, false);
 }
 
+static int dwc3_gadget_soft_connect(struct dwc3 *dwc)
+{
+	/*
+	 * In the Synopsys DWC_usb31 1.90a programming guide section
+	 * 4.1.9, it specifies that for a reconnect after a
+	 * device-initiated disconnect requires a core soft reset
+	 * (DCTL.CSftRst) before enabling the run/stop bit.
+	 */
+	dwc3_core_soft_reset(dwc);
+
+	dwc3_event_buffers_setup(dwc);
+	__dwc3_gadget_start(dwc);
+	return dwc3_gadget_run_stop(dwc, true, false);
+}
+
 static int dwc3_gadget_pullup(struct usb_gadget *g, int is_on)
 {
 	struct dwc3		*dwc = gadget_to_dwc(g);
@@ -2706,21 +2721,10 @@ static int dwc3_gadget_pullup(struct usb_gadget *g, int is_on)
 
 	synchronize_irq(dwc->irq_gadget);
 
-	if (!is_on) {
+	if (!is_on)
 		ret = dwc3_gadget_soft_disconnect(dwc);
-	} else {
-		/*
-		 * In the Synopsys DWC_usb31 1.90a programming guide section
-		 * 4.1.9, it specifies that for a reconnect after a
-		 * device-initiated disconnect requires a core soft reset
-		 * (DCTL.CSftRst) before enabling the run/stop bit.
-		 */
-		dwc3_core_soft_reset(dwc);
-
-		dwc3_event_buffers_setup(dwc);
-		__dwc3_gadget_start(dwc);
-		ret = dwc3_gadget_run_stop(dwc, true, false);
-	}
+	else
+		ret = dwc3_gadget_soft_connect(dwc);
 
 	pm_runtime_put(dwc->dev);
 
@@ -4674,42 +4678,39 @@ void dwc3_gadget_exit(struct dwc3 *dwc)
 int dwc3_gadget_suspend(struct dwc3 *dwc)
 {
 	unsigned long flags;
+	int ret;
 
-	if (!dwc->gadget_driver)
+	if (!dwc->gadget_driver || !dwc->softconnect)
 		return 0;
 
-	dwc3_gadget_run_stop(dwc, false, false);
+	ret = dwc3_gadget_soft_disconnect(dwc);
+	if (ret)
+		goto err;
 
 	spin_lock_irqsave(&dwc->lock, flags);
 	dwc3_disconnect_gadget(dwc);
-	__dwc3_gadget_stop(dwc);
 	spin_unlock_irqrestore(&dwc->lock, flags);
 
 	return 0;
+
+err:
+	/*
+	 * Attempt to reset the controller's state. Likely no
+	 * communication can be established until the host
+	 * performs a port reset.
+	 */
+	if (dwc->softconnect)
+		dwc3_gadget_soft_connect(dwc);
+
+	return ret;
 }
 
 int dwc3_gadget_resume(struct dwc3 *dwc)
 {
-	int			ret;
-
 	if (!dwc->gadget_driver || !dwc->softconnect)
 		return 0;
 
-	ret = __dwc3_gadget_start(dwc);
-	if (ret < 0)
-		goto err0;
-
-	ret = dwc3_gadget_run_stop(dwc, true, false);
-	if (ret < 0)
-		goto err1;
-
-	return 0;
-
-err1:
-	__dwc3_gadget_stop(dwc);
-
-err0:
-	return ret;
+	return dwc3_gadget_soft_connect(dwc);
 }
 
 void dwc3_gadget_process_pending_events(struct dwc3 *dwc)
-- 
2.34.1