[PATCH v2] hwmon: max31790: revise the scale to write pwm

[PATCH v2] hwmon: max31790: revise the scale to write pwm

[Delphine CC Chiu]

Since the value for PWMOUT Target Duty Cycle register is a 9 bit
left-justified value that ranges from 0 to 511 and is contained in 2
bytes.

There is an issue that the PWM signal recorded by oscilloscope would
not be on consistently if we set PWM to 100% to the driver.

It is because the LSB of the 9 bit would always be zero if it just
left shift 8 bit for the value that write to PWMOUT Target Duty
Cycle register.

Therefore, revise the scale of the value that was written to pwm input
from 255 to 511 and modify the value to left-justified value.

Signed-off-by: Delphine CC Chiu <Delphine_CC_Chiu@wiwynn.com>
---
 drivers/hwmon/max31790.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/hwmon/max31790.c b/drivers/hwmon/max31790.c
index 3dc95196b229..7aa1aa63bf1b 100644
--- a/drivers/hwmon/max31790.c
+++ b/drivers/hwmon/max31790.c
@@ -49,6 +49,9 @@
 
 #define NR_CHANNEL			6
 
+#define PWM_INPUT_SCALE	255
+#define MAX31790_REG_PWMOUT_SCALE	511
+
 /*
  * Client data (each client gets its own)
  */
@@ -343,10 +346,13 @@ static int max31790_write_pwm(struct device *dev, u32 attr, int channel,
 			err = -EINVAL;
 			break;
 		}
+
+		val = DIV_ROUND_CLOSEST(val * MAX31790_REG_PWMOUT_SCALE,
+					PWM_INPUT_SCALE);
 		data->valid = false;
 		err = i2c_smbus_write_word_swapped(client,
 						   MAX31790_REG_PWMOUT(channel),
-						   val << 8);
+						   val << 7);
 		break;
 	case hwmon_pwm_enable:
 		fan_config = data->fan_config[channel];
-- 
2.25.1

Re: [PATCH v2] hwmon: max31790: revise the scale to write pwm

[Guenter Roeck]

On Tue, Apr 16, 2024 at 10:22:11AM +0800, Delphine CC Chiu wrote:
> Since the value for PWMOUT Target Duty Cycle register is a 9 bit
> left-justified value that ranges from 0 to 511 and is contained in 2
> bytes.
> 
> There is an issue that the PWM signal recorded by oscilloscope would
> not be on consistently if we set PWM to 100% to the driver.
> 
> It is because the LSB of the 9 bit would always be zero if it just
> left shift 8 bit for the value that write to PWMOUT Target Duty
> Cycle register.
> 
> Therefore, revise the scale of the value that was written to pwm input
> from 255 to 511 and modify the value to left-justified value.
> 
> Signed-off-by: Delphine CC Chiu <Delphine_CC_Chiu@wiwynn.com>

Applied.

Thanks,
Guenter