[PATCH v1 1/2] pinctrl: baytrail: Use dedicated helpers for chained IRQ handlers

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

Instead of relying on the fact that the parent IRQ chip supports
fasteoi mode and calling the respective callback at the end of
the interrupt handler, surround it with enter and exit helpers
for chained IRQ handlers which will consider all possible cases.

This in particular unifies how GPIO drivers handle IRQ.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
 drivers/pinctrl/intel/pinctrl-baytrail.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/pinctrl/intel/pinctrl-baytrail.c b/drivers/pinctrl/intel/pinctrl-baytrail.c
index 7340dc20349c..c4458ac539ff 100644
--- a/drivers/pinctrl/intel/pinctrl-baytrail.c
+++ b/drivers/pinctrl/intel/pinctrl-baytrail.c
@@ -1355,6 +1355,8 @@ static void byt_gpio_irq_handler(struct irq_desc *desc)
 	void __iomem *reg;
 	unsigned long pending;
 
+	chained_irq_enter(chip, desc);
+
 	/* check from GPIO controller which pin triggered the interrupt */
 	for (base = 0; base < vg->chip.ngpio; base += 32) {
 		reg = byt_gpio_reg(vg, base, BYT_INT_STAT_REG);
@@ -1369,7 +1371,8 @@ static void byt_gpio_irq_handler(struct irq_desc *desc)
 		for_each_set_bit(pin, &pending, 32)
 			generic_handle_domain_irq(vg->chip.irq.domain, base + pin);
 	}
-	chip->irq_eoi(data);
+
+	chained_irq_exit(chip, desc);
 }
 
 static bool byt_direct_irq_sanity_check(struct intel_pinctrl *vg, int pin, u32 conf0)
-- 
2.43.0.rc1.1336.g36b5255a03ac