[PATCH 3/6] riscv: dts: spacemit: k1-musepi-pro: enable QSPI and add SPI NOR

[Andre Heider <a.heider@gmail.com>]

Add the QSPI controller node and describe the attached SPI NOR flash
(Winbond W25Q64FWSSAQ).

Add a corresponding vendor flash partition layout.

Signed-off-by: Andre Heider <a.heider@gmail.com>
---
 .../riscv/boot/dts/spacemit/k1-musepi-pro.dts | 43 ++++++++++++++++++-
 1 file changed, 42 insertions(+), 1 deletion(-)

diff --git a/arch/riscv/boot/dts/spacemit/k1-musepi-pro.dts b/arch/riscv/boot/dts/spacemit/k1-musepi-pro.dts
index 8bb85b5ba1943..32599082b3c36 100644
--- a/arch/riscv/boot/dts/spacemit/k1-musepi-pro.dts
+++ b/arch/riscv/boot/dts/spacemit/k1-musepi-pro.dts
@@ -166,7 +166,7 @@ buck3_1v8: buck3 {
 				regulator-always-on;
 			};
 
-			buck4 {
+			buck4_3v3: buck4 {
 				regulator-min-microvolt = <500000>;
 				regulator-max-microvolt = <3300000>;
 				regulator-ramp-delay = <5000>;
@@ -249,6 +249,47 @@ dldo7 {
 	};
 };
 
+&qspi {
+	pinctrl-names = "default";
+	pinctrl-0 = <&qspi_cfg>;
+	status = "okay";
+
+	flash@0 {
+		compatible = "jedec,spi-nor";
+		reg = <0>;
+		spi-max-frequency = <26500000>;
+		spi-rx-bus-width = <4>;
+		spi-tx-bus-width = <4>;
+		vcc-supply = <&buck4_3v3>; /* QSPI_VCC1833 */
+		m25p,fast-read;
+
+		partitions {
+			compatible = "fixed-partitions";
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			bootinfo@0 {
+				reg = <0x0 0x10000>;
+			};
+			private@10000 {
+				reg = <0x10000 0x10000>;
+			};
+			fsbl@20000 {
+				reg = <0x20000 0x40000>;
+			};
+			env@60000 {
+				reg = <0x60000 0x10000>;
+			};
+			opensbi@70000 {
+				reg = <0x70000 0x30000>;
+			};
+			uboot@a00000 {
+				reg = <0xa0000 0x760000>;
+			};
+		};
+	};
+};
+
 &uart0 {
 	pinctrl-0 = <&uart0_2_cfg>;
 	pinctrl-names = "default";
-- 
2.53.0