[PATCH v2 3/3] iio: adc: ti-ads1298: Remove unnecessary CONFIG2 write during init

[Md Shofiqul Islam <shofiqtest@gmail.com>]

The driver was enabling the internal test signal (INT_TEST), double
amplitude (TEST_AMP), and fast frequency (TEST_FREQ_FAST) bits in
CONFIG2 during initialization. These bits activate an internal square
wave generator intended for device testing and calibration, not normal
ECG operation.

CONFIG2 defaults to having only the RESERVED bit set after reset, which
is the correct value for normal operation. Remove the write entirely
since it would just be writing the reset default value.

Suggested-by: Mike Looijmans <mike.looijmans@topic.nl>
Signed-off-by: Md Shofiqul Islam <shofiqtest@gmail.com>
---
 drivers/iio/adc/ti-ads1298.c | 9 ---------
 1 file changed, 9 deletions(-)

diff --git a/drivers/iio/adc/ti-ads1298.c b/drivers/iio/adc/ti-ads1298.c
index 186bda3087..8957e873e1 100644
--- a/drivers/iio/adc/ti-ads1298.c
+++ b/drivers/iio/adc/ti-ads1298.c
@@ -615,15 +615,6 @@ static int ads1298_init(struct iio_dev *indio_dev)
 	if (!indio_dev->name)
 		return -ENOMEM;
 
-	/* Enable internal test signal, double amplitude, double frequency */
-	ret = regmap_write(priv->regmap, ADS1298_REG_CONFIG2,
-			   ADS1298_MASK_CONFIG2_RESERVED |
-			   ADS1298_MASK_CONFIG2_INT_TEST |
-			   ADS1298_MASK_CONFIG2_TEST_AMP |
-			   ADS1298_MASK_CONFIG2_TEST_FREQ_FAST);
-	if (ret)
-		return ret;
-
 	val = ADS1298_MASK_CONFIG3_RESERVED; /* Must write 1 always */
 	if (!priv->reg_vref) {
 		/* Enable internal reference */
-- 
2.54.0.windows.1