[patch 1/4] 2.4.20-pre2 i2c updates

[patch 1/4] 2.4.20-pre2 i2c updates

[Albert Cranford]

Hello Marcelo,
Please apply the following four tested patches that update
2.4.20-pre2 with these I2C changes:
o Support for SMBus 2.0 PEC Packet Error Checking
o New adapter-i2c-frodo for SA 1110 board
o New adapter-i2c-rpx for embeded MPC8XX
o Remove compat code for < 2.4
o Replace cli()&sti() with spin_{un}lock_irq()
o Updated documentation
Thanks,
Albert
--- linux/drivers/i2c/Config.in.orig    2002-07-23 01:47:14.000000000 -0400
+++ linux/drivers/i2c/Config.in 2002-07-23 01:47:14.000000000 -0400
@@ -32,10 +32,10 @@
          dep_tristate '  Embedded Planet RPX Lite/Classic suppoort' CONFIG_I2C_RPXLITE $CONFIG_I2C_ALGO8XX
       fi
    fi
-   if [ "$CONFIG_405" = "y" ]; then
-      dep_tristate 'PPC 405 I2C Algorithm' CONFIG_I2C_PPC405_ALGO $CONFIG_I2C
-      if [ "$CONFIG_I2C_PPC405_ALGO" != "n" ]; then
-         dep_tristate '  PPC 405 I2C Adapter' CONFIG_I2C_PPC405_ADAP $CONFIG_I2C_PPC405_ALGO
+   if [ "$CONFIG_IBM_OCP" = "y" ]; then
+      dep_tristate 'IBM on-chip I2C Algorithm' CONFIG_I2C_IBM_OCP_ALGO $CONFIG_I2C
+      if [ "$CONFIG_I2C_IBM_OCP_ALGO" != "n" ]; then
+         dep_tristate '  IBM on-chip I2C Adapter' CONFIG_I2C_IBM_OCP_ADAP $CONFIG_I2C_IBM_OCP_ALGO
       fi
    fi
 
@@ -47,7 +47,7 @@
 # This is needed for automatic patch generation: sensors code ends here
 
    dep_tristate 'I2C device interface' CONFIG_I2C_CHARDEV $CONFIG_I2C
-   dep_tristate 'I2C /proc interface (required for hardware sensors)' CONFIG_I2C_PROC $CONFIG_I2C
+   dep_tristate 'I2C /proc interface (required for hardware sensors)' CONFIG_I2C_PROC $CONFIG_I2C $CONFIG_SYSCTL
 
 fi
 endmenu

-- 
Albert Cranford Deerfield Beach FL USA
ac9410@bellsouth.net