Re: [PATCH v4 4/6] iio: dac: ad3530r: Refactor setup to table-driven register banks

[Andy Shevchenko <andriy.shevchenko@intel.com>]

On Fri, Jul 03, 2026 at 06:10:09PM +0800, Kim Seer Paller wrote:
> Devices with a multi-bank register map repeat the same configuration
> across several banks, which the hardcoded register addresses in
> ad3530r_setup() cannot cover.
> 
> Move the addresses into per-chip arrays and add ad3530r_set_reg_bank_bits()
> and ad3530r_write_reg_banks() to apply an operation to every bank. Each
> current device has a single bank, so no functional change.

Reviewed-by: Andy Shevchenko <andriy.shevchenko@intel.com>

...

> -	int i, ret;
>  	u8 range_multiplier, val;
> +	int ret;

> -	for (i = 0; i < st->chip_info->num_channels; i++)
> +	for (unsigned int i = 0; i < st->chip_info->num_channels; i++)

Strictly speaking this is separate change. But it's quite small, so I leave it
up to Jonathan to decide if needs to be split or okay to go as is.

-- 
With Best Regards,
Andy Shevchenko