* [PATCH v2] ethernet: cavium: octeon: Switch to using netdev_info().
@ 2017-10-24 17:04 Steven J. Hill
0 siblings, 0 replies; 2+ messages in thread
From: Steven J. Hill @ 2017-10-24 17:04 UTC (permalink / raw)
To: netdev; +Cc: Steven J. Hill, David Daney
Signed-off-by: Steven J. Hill <Steven.Hill@cavium.com>
Signed-off-by: David Daney <david.daney@cavium.com>
---
drivers/net/ethernet/cavium/octeon/octeon_mgmt.c | 27 +++++++++++-------------
1 file changed, 12 insertions(+), 15 deletions(-)
diff --git a/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c b/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c
index 2887bca..28e10dc 100644
--- a/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c
+++ b/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c
@@ -705,14 +705,15 @@ static int octeon_mgmt_ioctl_hwtstamp(struct net_device *netdev,
u64 clock_comp = (NSEC_PER_SEC << 32) / octeon_get_io_clock_rate();
if (!ptp.s.ptp_en)
cvmx_write_csr(CVMX_MIO_PTP_CLOCK_COMP, clock_comp);
- pr_info("PTP Clock: Using sclk reference at %lld Hz\n",
- (NSEC_PER_SEC << 32) / clock_comp);
+ netdev_info(netdev,
+ "PTP Clock using sclk reference @ %lldHz\n",
+ (NSEC_PER_SEC << 32) / clock_comp);
} else {
/* The clock is already programmed to use a GPIO */
u64 clock_comp = cvmx_read_csr(CVMX_MIO_PTP_CLOCK_COMP);
- pr_info("PTP Clock: Using GPIO %d at %lld Hz\n",
- ptp.s.ext_clk_in,
- (NSEC_PER_SEC << 32) / clock_comp);
+ netdev_info(netdev,
+ "PTP Clock using GPIO%d @ %lld Hz\n",
+ ptp.s.ext_clk_in, (NSEC_PER_SEC << 32) / clock_comp);
}
/* Enable the clock if it wasn't done already */
@@ -925,16 +926,12 @@ static void octeon_mgmt_adjust_link(struct net_device *netdev)
spin_unlock_irqrestore(&p->lock, flags);
- if (link_changed != 0) {
- if (link_changed > 0) {
- pr_info("%s: Link is up - %d/%s\n", netdev->name,
- phydev->speed,
- phydev->duplex == DUPLEX_FULL ?
- "Full" : "Half");
- } else {
- pr_info("%s: Link is down\n", netdev->name);
- }
- }
+ if (link_changed != 0)
+ if (link_changed > 0)
+ netdev_info(netdev, "Link is up - %d/%s\n",
+ phydev->speed, phydev->duplex == DUPLEX_FULL ? "Full" : "Half");
+ else
+ netdev_info(netdev, "Link is down\n");
}
static int octeon_mgmt_init_phy(struct net_device *netdev)
--
2.1.4
^ permalink raw reply related [flat|nested] 2+ messages in thread* [PATCH v2] ethernet: cavium: octeon: Switch to using netdev_info().
@ 2017-10-24 17:25 Steven J. Hill
0 siblings, 0 replies; 2+ messages in thread
From: Steven J. Hill @ 2017-10-24 17:25 UTC (permalink / raw)
To: netdev; +Cc: Steven J. Hill, David Daney
Signed-off-by: Steven J. Hill <Steven.Hill@cavium.com>
Signed-off-by: David Daney <david.daney@cavium.com>
---
drivers/net/ethernet/cavium/octeon/octeon_mgmt.c | 27 +++++++++++-------------
1 file changed, 12 insertions(+), 15 deletions(-)
diff --git a/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c b/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c
index 2887bca..28e10dc 100644
--- a/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c
+++ b/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c
@@ -705,14 +705,15 @@ static int octeon_mgmt_ioctl_hwtstamp(struct net_device *netdev,
u64 clock_comp = (NSEC_PER_SEC << 32) / octeon_get_io_clock_rate();
if (!ptp.s.ptp_en)
cvmx_write_csr(CVMX_MIO_PTP_CLOCK_COMP, clock_comp);
- pr_info("PTP Clock: Using sclk reference at %lld Hz\n",
- (NSEC_PER_SEC << 32) / clock_comp);
+ netdev_info(netdev,
+ "PTP Clock using sclk reference @ %lldHz\n",
+ (NSEC_PER_SEC << 32) / clock_comp);
} else {
/* The clock is already programmed to use a GPIO */
u64 clock_comp = cvmx_read_csr(CVMX_MIO_PTP_CLOCK_COMP);
- pr_info("PTP Clock: Using GPIO %d at %lld Hz\n",
- ptp.s.ext_clk_in,
- (NSEC_PER_SEC << 32) / clock_comp);
+ netdev_info(netdev,
+ "PTP Clock using GPIO%d @ %lld Hz\n",
+ ptp.s.ext_clk_in, (NSEC_PER_SEC << 32) / clock_comp);
}
/* Enable the clock if it wasn't done already */
@@ -925,16 +926,12 @@ static void octeon_mgmt_adjust_link(struct net_device *netdev)
spin_unlock_irqrestore(&p->lock, flags);
- if (link_changed != 0) {
- if (link_changed > 0) {
- pr_info("%s: Link is up - %d/%s\n", netdev->name,
- phydev->speed,
- phydev->duplex == DUPLEX_FULL ?
- "Full" : "Half");
- } else {
- pr_info("%s: Link is down\n", netdev->name);
- }
- }
+ if (link_changed != 0)
+ if (link_changed > 0)
+ netdev_info(netdev, "Link is up - %d/%s\n",
+ phydev->speed, phydev->duplex == DUPLEX_FULL ? "Full" : "Half");
+ else
+ netdev_info(netdev, "Link is down\n");
}
static int octeon_mgmt_init_phy(struct net_device *netdev)
--
2.1.4
^ permalink raw reply related [flat|nested] 2+ messages in thread
end of thread, other threads:[~2017-10-24 17:31 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2017-10-24 17:04 [PATCH v2] ethernet: cavium: octeon: Switch to using netdev_info() Steven J. Hill
-- strict thread matches above, loose matches on Subject: below --
2017-10-24 17:25 Steven J. Hill
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox