[PATCH net-next] net: phy: marvell: add LED support for 88E1116R PHY

[Konstantin Meshkov <skyline@mail.ru>]

The Marvell 88E1116R PHY (used on the D-Link DNS-325) exposes its LEDs
through the same page 3 register 0x10 LED control layout as the 88E1318S.
Wire up the existing 88E1318S LED handlers in the 88E1116R driver entry
so the PHY LEDs can be described in the device tree and driven through
the LED trigger API with hardware offload.

The LED polarity is configured through the led_polarity_set() callback
shared with the 88E1318S family.

Signed-off-by: Konstantin Meshkov <skyline@mail.ru>
---
This patch depends on:
[PATCH net-next v2] net: phy: marvell: add support for PHY LEDs polarity modes
https://patchwork.kernel.org/project/netdevbpf/patch/20260923204614.471409-1-olek2@wp.pl/

 drivers/net/phy/marvell.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/net/phy/marvell.c b/drivers/net/phy/marvell.c
index d57fcab..3b6c504 100644
--- a/drivers/net/phy/marvell.c
+++ b/drivers/net/phy/marvell.c
@@ -3949,6 +3949,12 @@ static struct phy_driver marvell_drivers[] = {
 		.get_stats = marvell_get_stats,
 		.get_tunable = m88e1011_get_tunable,
 		.set_tunable = m88e1011_set_tunable,
+		.led_polarity_set = m88e1318_led_polarity_set,
+		.led_brightness_set = m88e1318_led_brightness_set,
+		.led_blink_set = m88e1318_led_blink_set,
+		.led_hw_is_supported = m88e1318_led_hw_is_supported,
+		.led_hw_control_set = m88e1318_led_hw_control_set,
+		.led_hw_control_get = m88e1318_led_hw_control_get,
 	},
 	{
 		.phy_id = MARVELL_PHY_ID_88E1510,
-- 
2.39.5