[PATCH net-next] net: dsa: mt7530: select MEDIATEK_GE_PHY for NET_DSA_MT7530_MDIO

["Arınç ÜNAL" <arinc.unal@arinc9.com>]

Quoting from commit 4223f8651287 ("net: dsa: mt7530: make NET_DSA_MT7530
select MEDIATEK_GE_PHY"):

Make MediaTek MT753x DSA driver enable MediaTek Gigabit PHYs driver to
properly control MT7530 and MT7531 switch PHYs.

A noticeable change is that the behaviour of switchport interfaces going
up-down-up-down is no longer there.

Now, the switch can be used without the PHYs but, at the moment, every
hardware design out there that I have seen uses them. For that, it would
make the most sense to force the selection of MEDIATEK_GE_PHY for the MDIO
interface which currently controls the MT7530 and MT7531 switches.

Signed-off-by: Arınç ÜNAL <arinc.unal@arinc9.com>
---
 drivers/net/dsa/Kconfig | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/dsa/Kconfig b/drivers/net/dsa/Kconfig
index f8c1d73b251d..3092b391031a 100644
--- a/drivers/net/dsa/Kconfig
+++ b/drivers/net/dsa/Kconfig
@@ -48,7 +48,7 @@ config NET_DSA_MT7530
 config NET_DSA_MT7530_MDIO
 	tristate "MediaTek MT7530 MDIO interface driver"
 	depends on NET_DSA_MT7530
-	imply MEDIATEK_GE_PHY
+	select MEDIATEK_GE_PHY
 	select PCS_MTK_LYNXI
 	help
 	  This enables support for the MediaTek MT7530 and MT7531 switch
-- 
2.40.1