[net-next,v2,1/2] net: phy: realtek: Clean up RTL8211E ExtPage access

[Michael Klein <michael@fossekall.de>]

- Factor out RTL8211E extension page access code to
  rtl8211e_modify_ext_page()/rtl8211e_read_ext_page() and add some
  related #define:s
- Group RTL8211E_* and RTL8211F_* #define:s
- Clean up rtl8211e_config_init()

Signed-off-by: Michael Klein <michael@fossekall.de>
---
 drivers/net/phy/realtek/realtek_main.c | 64 +++++++++++++++++---------
 1 file changed, 42 insertions(+), 22 deletions(-)

diff --git a/drivers/net/phy/realtek/realtek_main.c b/drivers/net/phy/realtek/realtek_main.c
index 7a0b19d66aca..abea2291b0f4 100644
--- a/drivers/net/phy/realtek/realtek_main.c
+++ b/drivers/net/phy/realtek/realtek_main.c
@@ -28,13 +28,21 @@
 
 #define RTL821x_INSR				0x13
 
-#define RTL821x_EXT_PAGE_SELECT			0x1e
+#define RTL8211E_EXT_PAGE_SELECT		0x1e
 #define RTL821x_PAGE_SELECT			0x1f
 
+#define RTL8211E_SET_EXT_PAGE			0x07
+
+#define RTL8211E_CTRL_DELAY			BIT(13)
+#define RTL8211E_TX_DELAY			BIT(12)
+#define RTL8211E_RX_DELAY			BIT(11)
+
 #define RTL8211F_PHYCR1				0x18
 #define RTL8211F_PHYCR2				0x19
 #define RTL8211F_INSR				0x1d
 
+#define RTL8211F_CLKOUT_EN			BIT(0)
+
 #define RTL8211F_LEDCR				0x10
 #define RTL8211F_LEDCR_MODE			BIT(15)
 #define RTL8211F_LEDCR_ACT_TXRX			BIT(4)
@@ -51,12 +59,6 @@
 #define RTL8211F_ALDPS_ENABLE			BIT(2)
 #define RTL8211F_ALDPS_XTAL_OFF			BIT(12)
 
-#define RTL8211E_CTRL_DELAY			BIT(13)
-#define RTL8211E_TX_DELAY			BIT(12)
-#define RTL8211E_RX_DELAY			BIT(11)
-
-#define RTL8211F_CLKOUT_EN			BIT(0)
-
 #define RTL8201F_ISR				0x1e
 #define RTL8201F_ISR_ANERR			BIT(15)
 #define RTL8201F_ISR_DUPLEX			BIT(13)
@@ -134,6 +136,36 @@ static int rtl821x_write_page(struct phy_device *phydev, int page)
 	return __phy_write(phydev, RTL821x_PAGE_SELECT, page);
 }
 
+static int rtl8211e_read_ext_page(struct phy_device *phydev, u16 ext_page,
+				  u32 regnum)
+{
+	int oldpage, ret = 0;
+
+	oldpage = phy_select_page(phydev, RTL8211E_SET_EXT_PAGE);
+	if (oldpage >= 0) {
+		ret = __phy_write(phydev, RTL8211E_EXT_PAGE_SELECT, ext_page);
+		if (!ret)
+			ret = __phy_read(phydev, regnum);
+	}
+
+	return phy_restore_page(phydev, oldpage, ret);
+}
+
+static int rtl8211e_modify_ext_page(struct phy_device *phydev, u16 ext_page,
+				    u32 regnum, u16 mask, u16 set)
+{
+	int oldpage, ret = 0;
+
+	oldpage = phy_select_page(phydev, RTL8211E_SET_EXT_PAGE);
+	if (oldpage >= 0) {
+		ret = __phy_write(phydev, RTL8211E_EXT_PAGE_SELECT, ext_page);
+		if (!ret)
+			ret = __phy_modify(phydev, regnum, mask, set);
+	}
+
+	return phy_restore_page(phydev, oldpage, ret);
+}
+
 static int rtl821x_probe(struct phy_device *phydev)
 {
 	struct device *dev = &phydev->mdio.dev;
@@ -600,7 +632,8 @@ static int rtl8211f_led_hw_control_set(struct phy_device *phydev, u8 index,
 
 static int rtl8211e_config_init(struct phy_device *phydev)
 {
-	int ret = 0, oldpage;
+	const u16 delay_mask = RTL8211E_CTRL_DELAY |
+		RTL8211E_TX_DELAY | RTL8211E_RX_DELAY;
 	u16 val;
 
 	/* enable TX/RX delay for rgmii-* modes, and disable them for rgmii. */
@@ -630,20 +663,7 @@ static int rtl8211e_config_init(struct phy_device *phydev)
 	 * 12 = RX Delay, 11 = TX Delay
 	 * 10:0 = Test && debug settings reserved by realtek
 	 */
-	oldpage = phy_select_page(phydev, 0x7);
-	if (oldpage < 0)
-		goto err_restore_page;
-
-	ret = __phy_write(phydev, RTL821x_EXT_PAGE_SELECT, 0xa4);
-	if (ret)
-		goto err_restore_page;
-
-	ret = __phy_modify(phydev, 0x1c, RTL8211E_CTRL_DELAY
-			   | RTL8211E_TX_DELAY | RTL8211E_RX_DELAY,
-			   val);
-
-err_restore_page:
-	return phy_restore_page(phydev, oldpage, ret);
+	return rtl8211e_modify_ext_page(phydev, 0xa4, 0x1c, delay_mask, val);
 }
 
 static int rtl8211b_suspend(struct phy_device *phydev)
-- 
2.39.5