[PATCH net] bnxt_en: Gate TPH enablement behind BNXT_SUPPORTS_QUEUE_API check

[PATCH net] bnxt_en: Gate TPH enablement behind BNXT_SUPPORTS_QUEUE_API check

[Thomas Walsh]

In bnxt_request_irq(), pcie_enable_tph() is called unconditionally to
enable PCIe TPH when setting up interrupts.

If the NIC hardware or firmware capabilities do not support queue ops,
attempting to enable TPH during bnxt_request_irq() is unnecessary.

As a result a flood of "RX queue restart failed: err=-95"  messages is
seen upon boot.

Gate the call to pcie_enable_tph() and setting of bp->tph_mode
behind BNXT_SUPPORTS_QUEUE_API(bp) to ensure TPH is only initialized
on devices capable of supporting queue ops. This prevents a guaranteed
-EOPNOTSUPP error from occurring due to NULL operations.

Fixes: 1410c7416dc3 ("eth: bnxt: always set the queue mgmt ops")
Suggested-by: Michal Schmidt <mschmidt@redhat.com>
Signed-off-by: Thomas Walsh <thwalsh@redhat.com>
---
 drivers/net/ethernet/broadcom/bnxt/bnxt.c | 8 +++++---
 1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/broadcom/bnxt/bnxt.c b/drivers/net/ethernet/broadcom/bnxt/bnxt.c
index 1e4944f3e606..9a2bbfa38f76 100644
--- a/drivers/net/ethernet/broadcom/bnxt/bnxt.c
+++ b/drivers/net/ethernet/broadcom/bnxt/bnxt.c
@@ -11920,9 +11920,11 @@ static int bnxt_request_irq(struct bnxt *bp)
 #endif
 
 	/* Enable TPH support as part of IRQ request */
-	rc = pcie_enable_tph(bp->pdev, PCI_TPH_ST_IV_MODE);
-	if (!rc)
-		bp->tph_mode = PCI_TPH_ST_IV_MODE;
+	if (BNXT_SUPPORTS_QUEUE_API(bp)) {
+		rc = pcie_enable_tph(bp->pdev, PCI_TPH_ST_IV_MODE);
+		if (!rc)
+			bp->tph_mode = PCI_TPH_ST_IV_MODE;
+	}
 
 	for (i = 0, j = 0; i < bp->cp_nr_rings; i++) {
 		int map_idx = bnxt_cp_num_to_irq_num(bp, i);
-- 
2.55.0