From: Jacob Keller <jacob.e.keller@intel.com>
To: Intel Wired LAN <intel-wired-lan@lists.osuosl.org>
Cc: netdev@vger.kernel.org,
Maciej Machnikowski <maciej.machnikowski@intel.com>,
Anthony Nguyen <anthony.l.nguyen@intel.com>,
Przemyslaw Korba <przemyslaw.korba@intel.com>,
Grzegorz Nitka <grzegorz.nitka@intel.com>,
Petr Oros <poros@redhat.com>,
alexander.nowlin@intel.com, kevin.bross@intel.com,
ranjit.cavatur@intel.com,
Jacob Keller <jacob.e.keller@intel.com>
Subject: [PATCH iwl-net v2 03/14] ice: set in_use only after preparing Tx timestamp index
Date: Tue, 25 Aug 2026 15:53:27 -0700 [thread overview]
Message-ID: <20260825-jk-e825c-minimized-fixes-v2-3-8223f95d26e3@intel.com> (raw)
In-Reply-To: <20260825-jk-e825c-minimized-fixes-v2-0-8223f95d26e3@intel.com>
The ice_ptp_request_ts() function is used to request a timestamp index for
use with a packet. When reserving an index, it sets the start time and
saves a pointer to the skb into the appropriate index. The function marks
the in_use bit first before doing any of these steps. The IRQ handler which
clears the timestamps reads the in_use bits uses a lockless flow for
reading the in_use bits to determine which ones are in-use. This is
necessary as actually processing a complete timestamp must be able to sleep
so we cannot hold the timestamp tracker lock over the entire sequence.
Additionally, blocking the Tx hotpath with such a lock indefinitely would
be problematic.
However, the existing flow now has a very narrow window where the IRQ
handler could see a timestamp as in-use but read a stale value for its
"start" time.
Fix this by ordering the sequence to mark the in_use bit last, and add a
memory barrier to prevent re-ordering of the previous writes to setup the
index.
This was found and reported by Sashiko while reviewing an unrelated change.
Closes: https://sashiko.dev/#/patchset/20260821-jk-e825c-minimized-fixes-v1-0-9d0731eb4858%40intel.com?part=7
Fixes: ea9b847cda64 ("ice: enable transmit timestamps for E810 devices")
Signed-off-by: Jacob Keller <jacob.e.keller@intel.com>
---
drivers/net/ethernet/intel/ice/ice_ptp.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/intel/ice/ice_ptp.c b/drivers/net/ethernet/intel/ice/ice_ptp.c
index 142d39ee5cc5..68537705e839 100644
--- a/drivers/net/ethernet/intel/ice/ice_ptp.c
+++ b/drivers/net/ethernet/intel/ice/ice_ptp.c
@@ -2672,11 +2672,13 @@ s8 ice_ptp_request_ts(struct ice_ptp_tx *tx, struct sk_buff *skb)
* a reference to the skb and the start time to allow discarding old
* requests.
*/
- set_bit(idx, tx->in_use);
- clear_bit(idx, tx->stale);
tx->tstamps[idx].start = jiffies;
tx->tstamps[idx].skb = skb_get(skb);
skb_shinfo(skb)->tx_flags |= SKBTX_IN_PROGRESS;
+ clear_bit(idx, tx->stale);
+ /* Ensure index is setup before marking it as used */
+ smp_mb__before_atomic();
+ set_bit(idx, tx->in_use);
ice_trace(tx_tstamp_request, skb, idx);
}
--
2.55.0.814.gc42f45431d0f
next prev parent reply other threads:[~2026-08-25 22:55 UTC|newest]
Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-08-25 22:53 [PATCH iwl-net v2 00/14] ice: E82x: timestamp processing logic fixes Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 01/14] ice: use reference counting and RCU for PTP port access Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 02/14] ice: fix removal of PTP timestamp tracker during reset Jacob Keller
2026-08-25 22:53 ` Jacob Keller [this message]
2026-08-25 22:53 ` [PATCH iwl-net v2 04/14] ice: E822: keep Tx timestamps disabled during offset calibration Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 05/14] ice: E822: cancel offset verification work during reset preparation Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 06/14] ice: call PTP link change only from link events Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 07/14] ice: E825: stop clearing PHY_REG_TX_OFFSET_READY Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 08/14] ice: E825: clear PHY_REG_TX_MEMORY_STATUS prior to soft reset Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 09/14] ice: E825: perform a soft reset when starting the PHY timer Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 10/14] ice: wait for in-flight Tx timestamps before flushing the tracker Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 11/14] ice: keep Tx timestamp slots tracked until completion or timeout Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 12/14] ice: remove unnecessary discarding of timestamps after clock adjust Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 13/14] ice: skip reading Tx ready bitmap on ports with no timestamps Jacob Keller
2026-08-25 22:53 ` [PATCH iwl-net v2 14/14] ice: don't clear in_use until HW clears ready bitmap Jacob Keller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20260825-jk-e825c-minimized-fixes-v2-3-8223f95d26e3@intel.com \
--to=jacob.e.keller@intel.com \
--cc=alexander.nowlin@intel.com \
--cc=anthony.l.nguyen@intel.com \
--cc=grzegorz.nitka@intel.com \
--cc=intel-wired-lan@lists.osuosl.org \
--cc=kevin.bross@intel.com \
--cc=maciej.machnikowski@intel.com \
--cc=netdev@vger.kernel.org \
--cc=poros@redhat.com \
--cc=przemyslaw.korba@intel.com \
--cc=ranjit.cavatur@intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox