Re: [PATCH 3/3] arm64: dts: rockchip: Add RTL8367RB-VB switch to Radxa E24C

[Jonas Karlman <jonas@kwiboo.se>]

Hi Chukun,

On 7/29/2025 1:50 PM, Chukun Pan wrote:
> Hi,
> 
>> The issue is with TSO and RX checksum offload, with those disabled on
>> the conduit interface (gmac1/eth0) my issues disappeared.
> 
> I did a test today and the same problem occurred when running the new
> kernel on my rk3568 + rtl8367s board. This problem does not exist on
> older kernels (6.1 and 6.6). Not sure where the problem is.

I had only tested on a next-20250722 based kernel and on a vendor 6.1
based kernel. And similar to your findings, on 6.1 based kernel there
was no issue only on the newer kernel.

I will probably drop the use of "/delete-property/ snps,tso" and include
a note in commit message about the TSO and RX checksum issue for v2.

> 
>> With a 'mdio' child node 'make CHECK_DTBS=y' report something like:
>>
>>    rockchip/rk3528-radxa-e24c.dtb: ethernet-switch@1d (realtek,rtl8365mb): mdio: False schema does not allow { [snip] }
>>          from schema $id: http://devicetree.org/schemas/net/dsa/realtek.yaml#
>>
>> With a mdio node the driver is happy and dtschema is sad, and without
>> the mdio node it was the other way around.
> 
> On older kernels (6.1/6.6) only realtek-smi requires mdio child OF node.
> Commit bba140a566ed ("net: dsa: realtek: use the same mii bus driver for both interfaces")
> changed this behavior, both MDIO interface and SMI interface need it
> (rtl83xx_setup_user_mdio), but the dt-bindings has not been updated.
> I think this needs a Fixes tag.

Thanks for finding this, and yes I can see that commit bba140a566ed
changed the behavior of the driver and probably broke out-of-tree users.

My current plan for a v2 is to:
- include a new dt-bindings patch to allow use of a mdio node
- include a mdio node in the switch node
- add a Fixes tag to the driver patch

Then leave up to maintainers to decide if they want to accept this patch
or not.

Regards,
Jonas

> 
> Thanks,
> Chukun
> 
> --
> 2.25.1
> 
>