Re: [PATCH v2 1/2] dt-bindings: imx335: Mention reset-gpio polarity

[Krzysztof Kozlowski <krzk@kernel.org>]

On 29/07/2024 13:04, Umang Jain wrote:
> Mention the reset-gpio polarity in the device tree bindings.
> It is GPIO_ACTIVE_LOW according to the datasheet.
> 
> Signed-off-by: Umang Jain <umang.jain@ideasonboard.com>
> ---

IdeasOnBoard folks are seasoned developers, although I noticed from time
to time you do not cc all necessary addresses. I wonder why? Something
is missing in internal guideline?

That's not the first case, but pasting same form letter is a bit
annoying, especially considering that *tools tell you to do correct
stuff* and you do not need *person to tell you that*.


<form letter>
Please use scripts/get_maintainers.pl to get a list of necessary people
and lists to CC. It might happen, that command when run on an older
kernel, gives you outdated entries. Therefore please be sure you base
your patches on recent Linux kernel.

Tools like b4 or scripts/get_maintainer.pl provide you proper list of
people, so fix your workflow. Tools might also fail if you work on some
ancient tree (don't, instead use mainline) or work on fork of kernel
(don't, instead use mainline). Just use b4 and everything should be
fine, although remember about `b4 prep --auto-to-cc` if you added new
patches to the patchset.

You missed at least devicetree list (maybe more), so this won't be
tested by automated tooling. Performing review on untested code might be
a waste of time.

Please kindly resend and include all necessary To/Cc entries.
</form letter>

Best regards,
Krzysztof