[U-Boot] [PATCH] EXT4: Fix number base handling of "ext4write" command

[Wolfgang Denk <wd@denx.de>]

Dear Lukasz,

In message <20140131110818.07d79eac@amdc2363> you wrote:
> 
> > I do not see any such need.  Hex input base is the established and
> > documented default - ext4write is not a special command, so why should
> > we mention this here when we do not mention it anywhere else?
> 
> If now all <fs>*write and <fs>*load commands accept only hex input,
> then I agree, that extra comment is not needed.

Not only these, but all other commands - with the inglorious exception
of the "sleep" command (but hey - there must be a bad example
somewhere, right? ;-)

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
There are two ways of constructing a software design. One way  is  to
make  it  so  simple that there are obviously no deficiencies and the
other is to make it so complicated that there are  no  obvious  defi-
ciencies.                             - Charles Anthony Richard Hoare