[U-Boot] [PATCH v7 14/17] net: fec_mxc: Add 'phy-reset-gpios' support

["Lothar Waßmann" <LW@KARO-electronics.de>]

Hi,

On Tue, 23 May 2017 13:28:27 +0530 Jagan Teki wrote:
> From: Jagan Teki <jagan@openedev.com>
> 
> phy-reset-gpios property needed for adding mii_dev
> reset bus operation, so the board code not take care
> of phy_reset anymore if it use DM_ETH
> 
> Cc: Joe Hershberger <joe.hershberger@ni.com>
> Cc: Fabio Estevam <fabio.estevam@nxp.com>
> Signed-off-by: Jagan Teki <jagan@openedev.com>
> ---
>  drivers/net/fec_mxc.c | 64 +++++++++++++++++++++++++++++++++++++++++++++------
>  drivers/net/fec_mxc.h |  8 +++++++
>  include/netdev.h      |  5 ++++
>  3 files changed, 70 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c
> index 08bea8b..5e16f02 100644
> --- a/drivers/net/fec_mxc.c
> +++ b/drivers/net/fec_mxc.c
> @@ -180,13 +180,27 @@ static int fec_mdio_write(struct ethernet_regs *eth, uint8_t phyaddr,
>  static int fec_phy_read(struct mii_dev *bus, int phyaddr, int dev_addr,
>  			int regaddr)
>  {
> -	return fec_mdio_read(bus->priv, phyaddr, regaddr);
> +#ifdef CONFIG_DM_ETH
> +	struct fec_priv *priv = dev_get_priv((struct udevice *)bus->priv);
> +	struct ethernet_regs *eth = priv->eth;
> +#else
> +	struct ethernet_regs *eth = bus->priv;
> +#endif
> +
> +	return fec_mdio_read(eth, phyaddr, regaddr);
>  }
>  
>  static int fec_phy_write(struct mii_dev *bus, int phyaddr, int dev_addr,
>  			 int regaddr, u16 data)
>  {
> -	return fec_mdio_write(bus->priv, phyaddr, regaddr, data);
> +#ifdef CONFIG_DM_ETH
> +	struct fec_priv *priv = dev_get_priv((struct udevice *)bus->priv);
> +	struct ethernet_regs *eth = priv->eth;
> +#else
> +	struct ethernet_regs *eth = bus->priv;
> +#endif
> +
> +	return fec_mdio_write(eth, phyaddr, regaddr, data);
>  }
>  
>  #ifndef CONFIG_PHYLIB
> @@ -985,9 +999,36 @@ static void fec_free_descs(struct fec_priv *fec)
>  	free(fec->tbd_base);
>  }
>  
> +#if defined(CONFIG_DM_ETH) && defined(CONFIG_DM_GPIO)
> +static int fec_phy_reset(struct mii_dev *bus)
> +{
> +	struct fec_priv *priv = dev_get_priv((struct udevice *)bus->priv);
> +
> +	if (!dm_gpio_is_valid(&priv->reset_gpio))
> +		return 0;
> +
> +	/* phy reset */
> +	dm_gpio_set_value(&priv->reset_gpio, 0);
> +	udelay(100);
> +	dm_gpio_set_value(&priv->reset_gpio, 1);
> +	udelay(100);
> +
> +	return 0;
> +}
> +#endif
> +
> +#ifdef CONFIG_DM_ETH
> +struct mii_dev *fec_get_miibus(struct udevice *dev, int dev_id)
> +#else
>  struct mii_dev *fec_get_miibus(uint32_t base_addr, int dev_id)
> +#endif
>  {
> +#ifdef CONFIG_DM_ETH
> +	struct fec_priv *priv = dev_get_priv(dev);
> +	struct ethernet_regs *eth = priv->eth;
> +#else
>  	struct ethernet_regs *eth = (struct ethernet_regs *)base_addr;
> +#endif
>  	struct mii_dev *bus;
>  	int ret;
>  
> @@ -998,7 +1039,14 @@ struct mii_dev *fec_get_miibus(uint32_t base_addr, int dev_id)
>  	}
>  	bus->read = fec_phy_read;
>  	bus->write = fec_phy_write;
> +#ifdef CONFIG_DM_ETH
> +	bus->priv = dev;
> +# ifdef CONFIG_DM_GPIO
> +	bus->reset = fec_phy_reset;
> +# endif
> +#else
>  	bus->priv = eth;
> +#endif
>  	fec_set_dev_name(bus->name, dev_id);
>  
>  	ret = mdio_register(bus);
> @@ -1223,7 +1271,7 @@ static int fecmxc_probe(struct udevice *dev)
>  	if (ret)
>  		return ret;
>  
> -	bus = fec_get_miibus((uint32_t)priv->eth, dev_id);
> +	bus = fec_get_miibus(dev, dev_id);
>
This should be conditional on CONFIG_DM_ETH like the definition of
fec_get_miibus().

>  	if (!bus)
>  		goto err_mii;
>  
> @@ -1292,10 +1340,12 @@ static int fecmxc_ofdata_to_platdata(struct udevice *dev)
>  		return -EINVAL;
>  	}
>  
> -	/* TODO
> -	 * Need to get the reset-gpio and related properties from DT
> -	 * and implemet the enet reset code on .probe call
> -	 */
> +#ifdef CONFIG_DM_GPIO
> +	/* phy reset gpio */
> +	gpio_request_by_name_nodev(gd->fdt_blob, dev_of_offset(dev),
> +				   "phy-reset-gpios", 0,
> +				   &priv->reset_gpio, GPIOD_IS_OUT);
> +#endif
>  
>  	return 0;
>  }
> diff --git a/drivers/net/fec_mxc.h b/drivers/net/fec_mxc.h
> index 43a7d7b..74ede4a 100644
> --- a/drivers/net/fec_mxc.h
> +++ b/drivers/net/fec_mxc.h
> @@ -17,6 +17,10 @@
>  #ifndef __FEC_MXC_H
>  #define __FEC_MXC_H
>  
> +#ifdef CONFIG_DM_GPIO
> +# include <asm-generic/gpio.h>
> +#endif
> +
>  /* Layout description of the FEC */
>  struct ethernet_regs {
>  	/* [10:2]addr = 00 */
> @@ -254,6 +258,10 @@ struct fec_priv {
>  
>  #ifdef CONFIG_DM_ETH
>  	u32 interface;
> +
> +# ifdef CONFIG_DM_GPIO
> +	struct gpio_desc reset_gpio;
> +# endif
>  #endif
>  };
>  
> diff --git a/include/netdev.h b/include/netdev.h
> index 8eb8b46..e5668f4 100644
> --- a/include/netdev.h
> +++ b/include/netdev.h
> @@ -133,7 +133,12 @@ static inline int pci_eth_init(bd_t *bis)
>  	return num;
>  }
>  
> +#ifdef CONFIG_DM_ETH
> +struct mii_dev *fec_get_miibus(struct udevice *dev, int dev_id);
> +#else
>  struct mii_dev *fec_get_miibus(uint32_t base_addr, int dev_id);
> +#endif
> +
>  #ifdef CONFIG_PHYLIB
>  struct phy_device;
>  int fec_probe(bd_t *bd, int dev_id, uint32_t base_addr,


Lothar Waßmann