[U-Boot] [PATCH v3 2/5] mtd: nand: mxs_nand: allow to enable BBT support

[Stefan Agner <stefan@agner.ch>]

From: Stefan Agner <stefan.agner@toradex.com>

Add config option which allows to enable on flash bad block table
support. This has the same effect as when using the device tree
property "nand-on-flash-bbt" in Linux.

Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
---

Changes in v3: None
Changes in v2: None

 drivers/mtd/nand/mxs_nand.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/mtd/nand/mxs_nand.c b/drivers/mtd/nand/mxs_nand.c
index 9338f1889d..867549e530 100644
--- a/drivers/mtd/nand/mxs_nand.c
+++ b/drivers/mtd/nand/mxs_nand.c
@@ -1172,6 +1172,10 @@ void board_nand_init(void)
 
 	memset(&fake_ecc_layout, 0, sizeof(fake_ecc_layout));
 
+#ifdef CONFIG_SYS_NAND_USE_FLASH_BBT
+	nand->bbt_options |= NAND_BBT_USE_FLASH | NAND_BBT_NO_OOB;
+#endif
+
 	nand_set_controller_data(nand, nand_info);
 	nand->options |= NAND_NO_SUBPAGE_WRITE;
 
-- 
2.17.0