[U-Boot] [PATCH 3/3] ARM: imx6q_logic: With SPL_OF_CONTROL enabled, remove MMC init

[sbabic at denx.de <sbabic@denx.de>]

> Since the board uses SPL_OF_CONTROL now, we don't need to
> explicitly initialize the MMC driver, but we still need to
> pinmux the corresponding pins.  This patch removes the
> initialization code and leave just the muxing behind.
> Signed-off-by: Adam Ford <aford173@gmail.com>
> diff --git a/board/logicpd/imx6/imx6logic.c b/board/logicpd/imx6/imx6logic.c
> index b17a3b1d39..ab1c7f266e 100644
> --- a/board/logicpd/imx6/imx6logic.c
> +++ b/board/logicpd/imx6/imx6logic.c
> @@ -222,25 +222,15 @@ int board_mmc_init(bd_t *bis)
>  	switch (reg) {
>  	case 0:
>  		SETUP_IOMUX_PADS(usdhc1_pads);
> -		usdhc_cfg[0].esdhc_base = USDHC1_BASE_ADDR;
> -		usdhc_cfg[0].sdhc_clk = mxc_get_clock(MXC_ESDHC_CLK);
> -		gd->arch.sdhc_clk = usdhc_cfg[0].sdhc_clk;
>  		break;
>  	case 1:
>  		SETUP_IOMUX_PADS(usdhc2_pads);
> -		usdhc_cfg[1].esdhc_base = USDHC2_BASE_ADDR;
> -		usdhc_cfg[1].sdhc_clk = mxc_get_clock(MXC_ESDHC2_CLK);
> -		gd->arch.sdhc_clk = usdhc_cfg[1].sdhc_clk;
>  		break;
>  	}
>  
> -	return fsl_esdhc_initialize(bis, &usdhc_cfg[reg]);
> +	return 0;
>  }
>  
> -int board_mmc_getcd(struct mmc *mmc)
> -{
> -	return 1;
> -}
>  #endif
>  
>  static void ccgr_init(void)

Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================