Re: [PATCH 2/2] serial: Remove obsolete CONS_INDEX_n Kconfig options

[Andre Przywara <andre.przywara@arm.com>]

On Mon,  9 May 2022 00:10:55 -0500
Samuel Holland <samuel@sholland.org> wrote:

> These were only ever implied by sunxi platforms, and that usage has
> been removed. Current practice is to specify CONFIG_CONS_INDEX in each
> board's defconfig.
> 
> Signed-off-by: Samuel Holland <samuel@sholland.org>

Applied to sunxi/master.

Thanks!
Andre

> ---
> 
>  drivers/serial/Kconfig | 26 --------------------------
>  1 file changed, 26 deletions(-)
> 
> diff --git a/drivers/serial/Kconfig b/drivers/serial/Kconfig
> index 1e595d0600..71a0591697 100644
> --- a/drivers/serial/Kconfig
> +++ b/drivers/serial/Kconfig
> @@ -74,36 +74,10 @@ config TPL_SERIAL_PRESENT
>  	  This option enables the full UART in TPL, so if is it disabled,
>  	  the full UART driver will be omitted, thus saving space.
>  
> -# Logic to allow us to use the imply keyword to set what the default port
> -# should be.  The default is otherwise 1.
> -config CONS_INDEX_0
> -	bool
> -
> -config CONS_INDEX_2
> -	bool
> -
> -config CONS_INDEX_3
> -	bool
> -
> -config CONS_INDEX_4
> -	bool
> -
> -config CONS_INDEX_5
> -	bool
> -
> -config CONS_INDEX_6
> -	bool
> -
>  config CONS_INDEX
>  	int "UART used for console"
>  	depends on SPECIFY_CONSOLE_INDEX
>  	range 0 6
> -	default 0 if CONS_INDEX_0
> -	default 2 if CONS_INDEX_2
> -	default 3 if CONS_INDEX_3
> -	default 4 if CONS_INDEX_4
> -	default 5 if CONS_INDEX_5
> -	default 6 if CONS_INDEX_6
>  	default 1
>  	help
>  	  Set this to match the UART number of the serial console.